Hua Ju Xin Tong Ke Ji S680A 3 in 1 Charging Stations User Manual
- June 16, 2024
- Hua Ju Xin Tong Ke Ji
Table of Contents
Instructional Manual 3-in-1 Charging
Station
Introduction
Note: Please center your device close to the product launch area to ensure safe and effective charging of the device!
For better charging efficiency, it is recommended to use a Phone case with a thickness no more than 3mm,
Charging indicator status
Power on: The blue indicator flashes three times then turns off.
Stand by: The blue indicator turns off.
Charging: When charging the blue indicator turns on for 20 seconds then turn
off.
Specification
Model: S680A
Input interface : Type-C
Intput: 9V-2A 12V-2A
Output:
5 W/7.5W/10W/15W
5V-1A
2. 5W
Size: 9898127mm
Quality : ≈140g
Cautions
- It’s recommended to use the QC3.0 or PD adapter with output of at least 20W to avoid abnormal product functions or unstable charging of multiple devices at the same time.
- Do not put metal foreign objects in the charging area.
- Please keep the product away from fire and do not use in high temperature environment.
- Do not use in a moist environment.
Made in China
3-in-1 Charging Station
Model: S680A
Input interface: Type-C
Input: 9V=2A/12V-2A
Output:SW/7,5W/10W/15W
Output: 5V-1A (Max)
Output(iWatch): 2.5W(Max)
Package contents: S680A host 1 USB-C cable1 User manual *1
Color ◯
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
The FCC certification of this device refers to RF exposure testing performed
in typical operating conditions, where a person is no closer than 20
centimeters from the device surface at all times, except for non-repetitive
patterns with transient time intervals in the order of a second. Only in the
stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.
Made in China
Documents / Resources
| Hua
Ju Xin Tong Ke Ji S680A 3 in 1 Charging
Stations
[pdf] User Manual
S680A 3 in 1 Charging Stations, S680A, 3 in 1 Charging Stations, Charging
Stations, Stations
---|---