Cooltrax WT-V4 Wireless Sensor User Guide
- June 16, 2024
- Cooltrax
Table of Contents
Cooltrax Wireless Sensor Manual
Models
Sensor WT-V4
Probe WP-V4
Wedge WW-V4
Integrated Sensors
- Temperature
- Magnetic contact
- Accelerometer and shock
- Humidity
- Light sensor
Wireless Capability
Bluetooth 5 Low Energy (BLE) Long Range (LR)
Compliance
Regulatory
Australia and New Zealand
**United States
FCC ID: WSB-WT-V4
FCC ID: WSB-WW-V4
FCC ID: WSB-WP-V4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Warning – changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Warning – a separation distance of at least 20cm from the radiating
structure and the body of the user or nearby persons must be maintained to
comply with MPE (Maximum Permissible Exposure) requirements.
Canada
IC: 10944A-WTV4
IC: 10944A-WWV4
IC: 10944A-WPV4
CAN ICES-003 (A) / NMB-003 (A)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Warning – a separation distance greater than 20cm from the radiating element and the user and/or bystander must be maintained to comply with RF exposure requirements.
Safety
The ingress-protection rating of this product is . The package contains a Lithium-thionyl Chloride (Li-SOCl2) battery
Getting started
The Cooltrax Sensor has a single mode of operation (on) and can be switched off when not in use.
Checking the status
Hold the button for half a second
The light will indicate whether the sensor is currently on or off
Green = On
Red = Off
Changing the state of the sensor
Hold the button for half a second to see the current state of the sensor
Continue to hold the button until the light changes colour
From Red to Green = On
From Green to Red = Off
Factory reset
Warning! A factory reset will dispose of any data records being held on
the device
If you are having any issues with your sensor tag then you may need to perform
a factory reset.
Press the button five times
LEDs will flash red, green, red, green, red
For one minute after the factory reset the sensor will be available on
Bluetooth LE modulation before switching back to long-range modulation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>