YKARY YK221 High Efficiency Solar Lighting User Guide
- June 16, 2024
- YKARY
Table of Contents
SOLAR BULB
YK221 User Guide
LES JARDINS®
HIGH EFFICIENCY
SOLAR LIGHTING
Made on Earth
Powered by the Sun®
www.lesjardins.solar
Congratulations on purchasing this YKARY bulb! Brighter times are ahead for
you!
Below are the initial steps to set-up the bulb to suit your needs.
Place the YKARY bulb on a dark flat surface with the solar panel facing
down.
First step is to fully charge your YKARY bulb batteries by plugging in the
provided cable and attaching the magnetic plug to your product. Yes, this bulb
is solar. Charging via the micro USB cable is only necessary before the first
use. Leave your YKARY
bulb charging for 5 hours. Power source requirement is 5 volts, 2AMP.
Next – Unlock device by pressing the control button ( ) for 8 seconds until it
blinks once.
Then press once to unlock.
It will remain unlocked for 10 minutes before locking itself again to prevent
unwanted changes to your settings. Now you can choose your preference (mode)
below and follow the applicable steps. Use the control button ( ) to make your
selection.
IMPORTANT NOTE
Do not press the button rapidly. Wait for flashes in between each tap of the
control button
6 PRESET MODES:
- Eco smart 2700K. Auto start at sunset for 6 hours – Tap once, one flash.
- Eco smart 1800K. Auto start at sunset for 6 hours – Tap twice, two flashes.
- Eco motion 2700K. Auto start at sunset, idle at 50 lumens, 500 lumens when triggered by motion sensor for 20 seconds – Tap three times, three flashes.
- Eco motion 1800K. Auto start at sunset, idle at 50 lumens, 500 lumens when triggered by motion sensor for 20 seconds – Tap four times, four flashes.
- Custom 2700K: Dimmable 5 levels 500/ 400/ 300/ 200/ 100 lumen. Tap five times, five flashes. Hold to dim.
- Custom 1800K: Dimmable 5 levels 500/ 400/ 300/ 200/ 100 lumen. Tap six times, six flashes. Hold to dim.
Warranty
Warranty does not cover misuse or unintentional damages such as water immersion, a fall or drop generating visible scratches or invisible electronic damages inside the module.