Global Sources SWR07 Human Presence Sensor User Guide
- June 16, 2024
- global sources
Table of Contents
Global Sources SWR07 Human Presence Sensor User Guide
PRODUCT INSTROCTION
Blinking : The device enters pairing mode
ON/OFF :Power indicator, it can be controlled by app
USB Type-C
Long press: Press and hold the button for 5 seconds then the LED blinks, the device will enter pairing mode
Quick Setup
Note: It needs to install “Smart Life” and register an account first
(Search “Smart Life” in APP Store /Google Play or Scan below QR code to
install APP)
Power on the device
Device pairing
Pairing for Wi-Fi device:
It needs to connect your mobile phone to a Wi-Fi router first (please select
2.4G signal to connect, it doesn’t support 5G frequency) Press and hold the
button for 5 seconds then the LED blinks, Open “Smart Life” APP, Click”+” at
the top right corner and select “Add Device”. then follow the in-app
instructions to connect the device to your network.
Pairing for Non-Wi-Fi(Bluetooth/Zigbee etc.) device
The gateway needs to be added first (please refer the manual of gateway to add
it). Press and hold the button for 5 seconds then the LED blinks, enter
gateway homepage and click “Search new device” or “Add Devices” and follow the
in-app instructions to connect the device to your gateway.
Device Installation
Install the device at the place where you want the detection range is 120
degree and the detection distance is 6 meters.refer as below.
Instruction for app settings
At the upper right corner of home page, there is a switch to turn the sensor on/off
Click “Setting” at the device panel to enter the device setting page. There are some options for adjusting the device, refer to below:
Detected Range
It can be adjusted from 1.5-6 meters (the tolerance is 0.75 meters
Sensitivity adjustment
Tips : If the detected object is in a range of 3 meters, even a low sensitivity had been set, the micromovement also can be detected.
Hold Time
If it doesn’t detect anything. It can be set a time that how long will show nobody
Power LED
Enable/Disable the power indicator
Presence Alarm
Enable/Disable the presence alarm
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modi?cations to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>