Schlage Lock Company 47446668 NFC Reader Module Instruction Manual
- June 16, 2024
- Schlage Lock Company
Table of Contents
Schlage Lock Company 47446668 NFC Reader Module Instruction Manual
Exit device models
Mortise models
Tubular models
FCC Statements
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
t here is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct t he interference by one of the
following measures.:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an out let on a circuit different from t hat to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference t hat may cause undesired operation.
→ Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IC Statements
Industry Canada Statement
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and Its gain should be so chosen t hat the
equivalent isotopically radiated power (E.I.R.P.) is not more than that
necessary for successful communication.
Industry Canada Radiation Exposure Statement
This Device complies with Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two conditions: l ) this device may not
cause interference, and 2) this device must accept any interference, including
interference that may cause undesired operation of the device.
RSS-GEN
This Device complies with Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two
conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF Radiation Exposure Statement
This equipment complies with FCC RF Radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunct ion with any other antenna or transmitter, other than
those approved for collocated use by Allegion. This equipment should be
installed and operated with a normally maintained separation distance of at
least 20 cm between t he radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>