NINGBO LIANDA LX001 Edge Single Engine Remote Control

Product Information

Specifications

• Remote Control Distance: 26 meters
• Frequency : 315MH
• Emitter Voltage : DC3.6V
• Receiver Voltage : DC9-15V

Product Usage Instructions

Turning on the Device

1. Press and hold the IN and OUT keys simultaneously for 3 seconds.
2. The blue wireless indicator light will remain on, indicating that the device is turned on.

Winch Output

To indicate the winch output, follow these steps:

1. Press the OUT button.
2. The blue indicator light will flash.
3. The flashing blue light indicates the winch output, which can be either nylon rope or steel wire rope.

Winch Wire Entry

To enter the wire into the winch, follow these steps:

1. Press the IN button.
2. The blue indicator light will flash.
3. The flashing blue light indicates that the winch is ready to receive the wire, which can be either nylon rope or steel wire rope.

FAQ

Q: What is the remote control distance?

A: The remote control distance is 26 meters.

Q: What is the frequency of the remote control?

A : The frequency of the remote control is 315MH.

Q: What are the voltage requirements for the emitter and receiver?

A : The emitter voltage is DC3.6V, and the receiver voltage is DC9-15V.

Q: Can the device be used in portable exposure condition?

A: Yes, the device has been evaluated to meet general RFexposure requirements and can be used in portable exposure conditions without restriction.

Remote Control Instructions

1. The function description of the panel buttons is shown in the

Function description

figure

1. Press and hold the IN and OUT keys for 3 seconds to turn on the device, and the blue wireless indicator light will remain on. Press the OUT button and the blue indicator light will flash to indicate the winch output (nylon rope/steel wire rope). Press the IN button and the blue indicator light will flash for the winch to enter the wire (nylon rope/steel wire rope).
2. Remote control distance: 26 meters, frequency: 315MH
3. Emitter voltage: DC3.6V Receiver voltage: DC9-15V

• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,  including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio  communications. However, there is no guarantee that interference will not occur in a particular installation.
  If this equipment does cause harmful interference to radio or television reception,
  which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

• The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>