Exceed 390 Divided King Installation Guide
- June 16, 2024
- Exceed
Table of Contents
Exceed
Divided King Installation Guide
See Owner’s Manual for complete operating instructions.
PART LIST
Before discarding the packing materials- ensure all the parts are accounted
for.
Some parts may be attached to the base or inside boxes, please inspect
carefully.
(4) Claw Bolt
(4) Washer
(4) Big Washer
(2) Short Bolt
(2) Nut
(4) Cotter Pin
(4) Clevis Pin
(4) Green Bushing
(1) 6mm Hex Wrench
(1) 13mm Wrench
STEP 1
a. Always use two people when setting up the base. Push and align the head and
foot sections together, making sure to align both brackets for each side
properly as seen here:
b. Loosely secure
the head and foot sections together by fastening halves with (2) Short Bolts,
washers and nuts.
STEP 2
Use Claw bolts(2pcs)/ Big washer (2pcs)to connect the head and foot frames.
STEP 3
Use Claw bolts(2pcs)/ Big washer (2pcs) to connect the head and foot frames.
STEP 4
Secure any loosely connected bolts, washers and nuts using the supplied 13mm
wrench and 6mm hex wrench.
STEP 5
Unpack head and foot motors from base (head motor is larger of the two).
Remove the cotter pin and pull out the clevis pin. Place both ends of the
motor into the appropriate bracket and make sure the Green Bushings go outside
of the metal mouting bracket. Slide the clevis pin through the bracket and
motor. Secure by reinserting cotter pin.
STEP 6
Attach the 6 legs by screwing them into the leg bolts at the center connection
points and all four corners as seen here:
(If installing headboard brackets, please see steps below.)
Headboard Bracket Installation
A 9/16” (14mm) and 1/2” (13mm) socket and crescent wrench are necessary to
complete installation.
A. Align the hole in the bracket to the brass sleeve into which the leg
threads. Hold the bracket in place and screw the leg into the base until it is
snug. DO NOT OVERTIGHTEN. (Too much force may cause the leg to spin freely.)
B. Align the tab with the hole in the frame (located towards the foot of the
base) and use a short bolt and nut to secure the bracket. Make sure the bolt
is tight.
Attach the plastic spacer and T-Bracket.
C. Measure the distance between the mounting holes on the headboard and
install the spacer and attachment plate to accommodate the headboard.
D. To install the plastic spacer and attachment plate, you will need (2) long
bolts and (2) nuts. Place the spacer and attachment plate in the desired
location and slip the bolts through the holes with the head of the bolt facing
outward. Position the bolts diagonally on the spacer. Use the 9/16” (14mm)
socket and wrench to tighten the bolts.
STEP 7
Locate and connect the FOOT VIBRATION cable and FOOT motor cable into their
respectively labeled ports on the control box. Then plug the offline voice
control puck into the MULTIFUNCTION PORT on the control box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>