PEXXUS W368 3 in 1 Magnetic Wireless Charger User Manual
- June 16, 2024
- PEXXUS
Table of Contents
W368 3
in 1 Magnetic Wireless Charger
**User Manual
**
Function Introduction
Package Content
Indicator Light Status
Status
Power on Notification| Indicator
Blue light Hashes 2 times and off
---|---
Standby Mode| Blue light off
Charging Status Notification| Blue light on
Fu I Charge Notification Foreign Object Detection Alert| Blue light on
Green light f ashes Artily the alarm is lifted
Lighting Modes
- Tap/Touch the top each time, the lights in the charging compartments on the left & right sides will proceed in the %Bowing sequence: Cozy mode 0 RGB mode Q) Turn off
- Cozy mode: Warm-Yellow light
- RGB mode:
1.Rapid Rotation
2.Fluctuating Display
3.Pulsating Display
4.Fading Display
(Note: In this mode, the lights are displayed and alternately lit in the following sequence. They will illuminate 3 times before transitioning to the next style.)
Compatibility List
Specification
Model | W368 |
---|---|
Input | 5V-3A, 9V-3A |
Output (iPhone) Output (AirPods) | 10W/7.5W 3W |
Output (Apple Watch) | 2.5W |
Before Charging
For the faster-charging performance please follow these steps :
- Update your IOS system to 15 and up
HOW to Use?
-
Connect the Fast Charger to the USB-C interface, the indicator blue light will briefly illuminate for 2 seconds and turn off. The ring light will activate in Cozy made, indicating it is in standby mode.
-
iPhone Charging:
2.The indicator blue light will stay on continuously, confirming the iPhone is charging normally;
3. lf the iPhone is not charging normally, the green light will rapidly flash. -
AirPods Charging:
Note: Please ensure to remove any 3mm silicone protective cover from your AirPods, it may interfere with the charging process. -
Apple Watch Charging:
Note: For optimal charging, please make sure to detach the watch band before charging your Apple Watch.
Warm tips
Please pay attention to the following issues, otherwise it may cause abnormal charging, high charging temperature, intermittent charging, or even no charging.
- Please place your iPhone/Apple Watch/AirPods in the correct charging area.
- Please use the original Fast Charger in the package, which can charge 3 devices at the same time while maintaining the fastest speed.
- The charging thickness is 2-8mm, please do not wear a protective cover that is thicker than 3mm.
- No metal or magnetic objects around 6cm of the back center of the phone during charging.
- The lower temperature, the faster the charging speed. High tempera- true will influence the charging speed.
- Please don’t charge in high temperature and humid environments to avoid damage to the circuit.
- Put it at the place that children can’t reach to avoid unnecessary accidents.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation
is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Need any helps, please contact us:
service@pexx-us.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>