BETTERLIFE SA200 Projector Light User Manual

BETTERLIFE SA200 Projector Light User Manual

Panel introduction

Button description

CAUTION
To avoid strong light radiation, please do not disassemble the panel. Adapter: DC5V 1A(min

Select scene effect
Power on/off
Aurora brightness adjustment
Select aurora color
Sound mode/Auto mode
Assisted sleep mode

How to use the Base?

Desktop placement
Align the mounting socket of the base vertically with the plug of the base and push it to the end. You can choose either a 25-degree angle base or a 45-degree angle base as needed. **(Figure 1)

**

Wall installation

• Use screws to fix the base to the wall. (Figure 2)
  

• Insert the light into the base to use **(Figure 3)

**

RF Remote control introduction

Autorun mode or switching work mode
Sound mode
Assisted sleep mode
Select aurora color
Select scene effect
Breath mode
Select sleep mode, the light will change to breathe mode about 10 minutes later, and it will automatically shutdown after about one hour.
The blue light flashes to indicate that the timing setting is successful, and “CANCEL” button can cancel the timer shutdown setting

BATTERY INSTALLATION FOR REMOTE CONTROL

1. Pull the battery tray out of the battery compartment of Remote Control.
2. Place new CR2025 button cell battery in the tray slot, as per the indicated polarity.
3. Close the battery tray

Battery may not be included due to Aviation Safety.

Caution

1. Please do not look directly at the light source output hole of the projector light while using it, otherwise it may cause eyes discomfort.
2. This product is suitable for dry environments, and please avoid using it in humid, overheated, and dusty environments. Good heat dissipation around the product, away from flammable objects or liquids.

Specification

Packing List

Projector light: 1
Remote control: 1
USB cable: 1
User manual: 1
Base: 2

Warning
Aperture do not expose to the naked eye, avoid direct eye contact. It is prohibits to expose the naked eyes directly to the projector light. otherwise it may injure the eyes.

FCC Caution:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>