LED s work 20W Work Light for Power Tool Batteries Adapter Instructions
- June 4, 2024
- LED s work
Table of Contents
LED s work 20W Work Light for Power Tool Batteries Adapter
20W work light FOR POWERT0OL BATTERIES Incl. Adapter
Caution! Risk of electric shock.
INSTALLATION
Safety warning
Ensure you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram (when applicable). Keep this document for future reference and only use the product as described in this document. Any other use of the product than described in this manual may damage the product or cause injury to the user (eg. due to a short circuit, fire or electric shock). Disconnect the product from the power source if problems occur. Do not drop the product and avoid bumping. Do not use the product if part is damaged or defective. Replace a damaged defective product immediately. When a non-standard consumer (power installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. Make sure the product is Sufficiently ventilated during use. Never covers an electrical [LED) device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so don’t stare at it directly. When a product is meant for indoor and/or outdoor use only, this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.
cleaning and Maintenance Warning!
Do not use cleaning solvents or abrasives. Do not clean the inside of the
device. Do not attempt to repair the device when the device does not operate
correctly, replace it.
Clean the outside of the device using a soft, damp cloth (don’t use a
microfiber cloth).
support
lf you need further help or have comments or suggestions please visit
www.shada.nl/nl/contact
D.0.C.I https://www.shada.n/p/300908
SHADA
Molenmakershoek 28,NL-7328 JK APELDOORN-The Netherlands
wuww.shada.nl