Bitop BT004 2.4G Smart Fan Light Controller Instructions
- June 16, 2024
- Bitop
Table of Contents
Bitop BT004 2.4G Smart Fan Light Controller Instructions
Instruction for Use
Product information:
Product name:: 2.4G-smart fan light controller
Model: BT004
Product parameter information:
Frequency : 2402-2480MHz
Modulation: GFSK
Data rate: 1Mbps
Channel number: 40CH
Power Supply : DC 3V
Battery: 1.5V×2AAA
Instructions of Product
- light on/key: the lamp is fully lit, at this time press the lamp switch for the first time, the lights are all off, press two times, the light is white, press the third time, the lights are off, press the fourth time, the warm light, press the fifth time, the lights are off, press the sixth time, the lights are all lit, if magainin accordance with the previous cycle; The buzzer does not sound on time.
- brightness +, brightness – key: when the lamp is on, press the brightness + or brightness – key to adjust the brightness, and the buzzer will not ring on time; Long press for non-polar dimming, point press a plus or minus one pole, maximum and minimum between ten poles.
- color temperature +, color temperature – key: when the lam piston, press the color temperature + or color temperature – key to adjust the color temperature back and forth, on time
Safety Caution:
- When using any remote control for the first time, appropriate batteries should be loaded first;
- Ensure that the LED light of the main control device and the motor device are correctly connected;
- Check whether the power supply of the main control devices properly connected, and the device is fully powered donna enters the standby state. 4, and then learn the code with the master, learn the code cane used normally;
- Finally, select different functions according to the needs;
Note: there is no sound when the function related to the lam pisoperated, and the sound when the function related to the motor is operated;
This device complies with Part 15 of the FCC Rules. Operations subject to the following two conditions:
- this device may not cause harmful interference, and this device must accept any interference received, in clouding interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses andcanradiate radio frequency energy and, if not installed and use din accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur inaparticular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technicianforhelp.
Warning: changes or modifications not expressly approvedbythe party responsible for compliance could void the user’s authority to operate the equipment The devices has beenevaluated to meet general RF exposure requirement, The devicecan be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>