Zhongshan Bitop Intelligent Control Technology BT001 2.4G-Smart Fan Light Controller Instruction Manual
- June 8, 2024
- Zhongshan Bitop Intelligent Control Technology
Table of Contents
Zhongshan Bitop Intelligent Control Technology BT001 2.4G-Smart Fan Light
Controller Instruction Manual
Instruction for Use
Product information:
- Product name: 2.4G-smart fan light controller
- Model: BT001
Product parameter information:
- Frequency: 2402-2480MHz
- Modulation: GFSK
- Data rate: 1Mbps
- Channel number: 40CH
- Power Supply: DC 3V
- Battery: 1.5V×2AAA
Instructions of Product
- light on/key: the lamp is fully lit, at this time press the lamp switch for the first time, the lights are all off, press two times, the light is white, press the third time, the lights are off, press the fourth time, the warm light, press the fifth time, the lights are off, press the sixth time, the lights are all lit, if again in accordance with the previous cycle; The buzzer does not sound on time.
- brightness +, brightness – key: when the lamp is on, press the brightness + or brightness – key to adjust the brightness, and the buzzer will not ring on time; Long press for non-polar dimming, point press a plus or minus one pole, maximum and minimum between ten poles.
- color temperature +, color temperature – key: when the lampion, press the color temperature + or color temperature – key to adjust the color temperature back and forth, on time.
Safety Caution:
- When using any remote control for the first time, appropriate batteries should be loaded first;
- Ensure that the LED light of the main control device and the motor device are correctly connected;
- Check whether the power supply of the main control devices properly connected, and the device is fully powered on and enters the standby state.
- and then learn the code with the master, learn the code can be used normally;
- Finally, select different functions according to the needs;
Note: there is no sound when the function related to the lamp is operated, and the sound when the function is operated;
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operations subject to the following two conditions:
(1) this device may not cause harmful interference, and this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
The devices has been evaluated to meet general RF exposure requirement, The
device can be used in portable exposure condition without restriction.