Buster Punch 299097 Gang Switch White Instruction Manual
- June 16, 2024
- BUSTER Punch
Table of Contents
Buster Punch 299097 Gang Switch White Instruction Manual
Instruction
Before commencing work, isolate the mains power supply at the circuit breaker.
CAUTION:
Verify power supply is OFF before proceeding.
If unit is to be used as a replacement for an existing product, remove existing unit from its location and disconnect the wiring.
Remove the unit from its packaging. Remove the coin cap screws (A) using
tool provided. If not released with the coin cap screws, unscrew the is olat
or plugs (B). This will reveal the mounting screws required for
installation (C).
To avoid damage to the coin caps, always fasten using the plastic tool
provided.
OPTIONAL: BLING YOUR TOGGLE SWITCH
Requires Toggle Details Kit. If you do not wish to change toggle details,
proceed to step 5.
A) Unscrew the existing toggle arm by hand, and set aside.
B) Holding the toggle module in place, unscrew the toggle nut using the
tool provided. Reverse this step to fit the new toggle nut, taking care not to
cross the thread.
C) With the nut in place, screw on the toggle arm from your details kit.
Note: coin caps fitted after install.
Connect the wires as shown in the appropriate wiring diagram. Use red or brown sleeving to mark cables used for ACTIVE or SWITCHED ACTIVE connections.
Ensure terminals are properly tightened and no bare wire is visible.
WAY SWITCHING ON T YPICAL LOOPED CIRCUIT
Pre-existing earth cables should be capped inside the back box.
WAY SWITCHING ON T YPICAL LOOPED CIRCUIT
Pre-existing earth cables should be capped inside the back box.
Push the wired unit into the mounting box, making sure that no wires become
trapped. Use a cross head screwdriver to fit the unit to the back box via the
two mounting screws as shown. To finish, fit the coin caps and is olator plugs
using the tool provided.
Once safely fitted, reconnect the mains supply at the circuit breaker.
TECHNICAL SPECIFICATION
1G – 4G TOGGLE SWITCH 250VAC / 10A Max / Class II
IMPORTANT NOTES
READ BEFORE INSTALLATION
- All wiring and installation must adhere to the latest local and national regulations.
- Must be installed by a licensed electrician.
- Do not exceed the rated power values.
- Indoor use only.
- To reduce the risk of discoloration or tarnishing, avoid installation on wet plaster.
AS/NZS 3133:2013 + A1:2014 + A2:2016
WARRANTY INFORMATION
The warranty period extends two (2) years from the date of the original purchase.
RECYCLING ELECTRICAL PRODUCTS
Buster and Punch encourages all its customers to make note of this symbol and avoid putting any waste electrical goods in your domestic waste bin or container. Please ensure you take your waste electrical goods to a suitable facility for disposal.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>