Baby Gate YG-30 Auto Close Safety Metal Dog Pet Gate Installation Guide
- June 16, 2024
- Baby Gate
Table of Contents
SAFETY GATE
Installation Guide
Product & Parts
The picture is only for reference,
please make the object as the standard.
WARNING: This package contains small parts and sharp points in an
unassembled state. Keep out of reach of children. Adult assembly required.
WARNING:
To help your installation,Do not cut off the belt before installation is
completed! The door gap is NOT a defect! It will be shortened to 0.075” after
installation.
Notice: screw in Mounting Cups
when using gate on stairs
MAINTENANCE
Clean by using a sponge with warm water or mild detergent. DO NOT use abrasive
cleaners or bleach.
Check the gate regularly to ensure all hardware and mounts are securely
tightened.
Do NOT use if any component is damaged or missing.
STEP 1. Measure the width of the doorways.
Following the below extension combination suggestions to install the
gate.
STEP 2.
nsert 4 bolts into 4 corners of the gate/extension. 
STEP 3.
Pre-assemble the gate, and locate four
points for hole drilling. Hold the wall cup in position and mark the center
with a pencil.
PLEASE NOTE: The gate should be resting on the floor. DO NOT allow a gap
of more than 0.5cm between the gate and the floor.
STEP 4.
Stick pad when using pressure mounted installation.
Remove two side of the sticky pad, stick 4 pads to 4 wall cups. Then wall cups
cover the bolts.
TIP: If you do not have to worry about damaging the walls, skip this
step.
STEP 5.
Drill hole for the 4 marked positions, then put dry wall anchor(g)and use
screw(f)and the wall cup (d)
STEP 6.
Tighten the top of the tension knobs by turning them clockwise at the same
time
Note: Make sure the bottom of the gate frame remains completely flat on
the floor.
Next, tighten the bottom of the tension knobs at the top on the same time by
turning them clockwise. STEP 7.
Cut off the belt and test the gate:- Push the gate to check stability.
- Open and close the walk through gate
Pull the button to the right, then lift the gate panel UP to open.
TROUBLE SHOTING
WARNING
- To prevent serious injury or death, securely install gate or enclosure and use according to manufacturer’s instructions.
- Never use with a child able to climb over or dislodge the gate or enclosure.
- This product will not necessarily prevent all accidents.
- Never leave child unattended.
- Use only with the locking mechanism securely engaged
- Intended for use with children from 6 months through 24 months of age.
- Stop using gate if any parts are missing or become damaged.
- Children have died or been seriously injured when gates are not securely installed.
- ALWAYS install and use gates as directed using all required parts.
- Periodically check all fasteners to be sure they are tight and secure.
- Adult Assembly Required.
- The surfaces that the gate is to fixed to must be suitable for the purpose and must be structurally sound.
- Indoor use only , is not to be exposed to outdoor elements.
- Install this gate away from heaters and other sources of heat.
- STOP using when a child can climb over or dislodge the gate.
- You MUST install [wall cups] to keep gate in place. Without [wall cups], child can push out and escape.
- NEVER use to keep child away from pool.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>