Sunoony MD-C800 LED Camping Lantern Rechargeable User Manual

Table of Contents

USER MANUAL
**Outdoor Camping Lantern

**

Sunoony MD-C800 LED Camping Lantern Rechargeable - ALARM
Light

Press the lantern button for the first time, and the lantern will be turned on at the lowest brightness.
Press the lantern button for the second time, and the lantern will be turned to medium brightness.
Press the lantern button for the third time, and the lantern will be turned to the highest brightness.
Press the lantern button for the fourth time, and the lantern will be turned off.

Press and hold the SOS button for 3s, and the SOS alarm light will flash and turn red.
Press the SOS button once more, the SOS alarm light will be turned off.

Press the flashlight button for the first time, and the flashlight will be turned on with the far beam.
Press the flashlight button for the second time, the flashlight will be turned to dipped beam. and
Press the flashlight button for the third time, and both the far beam and the dipped beam will be turned on.
Press the flashlight button for the fourth time, and the flashlight will be turned off.

When your turn the cap, the reading lamp will be turned on at the lowest brightness.
Press the reading lamp button for the first time, and the reading lamp will be turned to the medium brightness.
Press the reading lamp button for the second time, and the reading lamp will be turned to the highest brightness
Turn back the cap, the reading lamp will be turned off.
NOTE :
The button only controls the brightness, not control the on/off
When the reading lamp is on, the button will control the brightness of the reading lamp first

Connect the adaptor and the supplied Type-C cable with the Type-C input port of the unit to charge the built-in Li-ion battery, and the battery indicator will light on when charging.
The 4000mAh built-in Li-ion battery can provide emergency power to your phone in emergencies via the USB output port.

This unit has 4 blue power indicators to show the power capacity.

NOTE :

When turning on the Lantern/Flashlight/SOS ,the power indicator light will be on for 30 seconds.
The power indicator will stay on when charging and discharging

Unscrew the screw with a screwdriver to remove the battery cap under this unit.
Insert 3 AAA batteries in the correct direction.
The machine can be powered by 3 AAA batteries, but in he process of using 3 AAA batteries, the machine can not be USB charged or discharged, and can only be used for emergency lighting.

To protect the chip, the power supply will be cut off to protect the battery from damage when there is an overload or a short circuit in this unit.
It will cut off the power source when the voltage is lower than 2.7V the protects the battery from being over-discharged and damaged.

The device shall not be strongly impacted, beaten, and not be in contact with corrosive liquids.
Please do not over-discharge the unit, so as not to reduce the internal battery life, or damage the battery. Please take out the charging cable when the indicator light changes to avoid over charge.
Avoid flashlight light directly into the eyes, or it will hurt the eyes.
Non-professionals should not disassemble the device to prevent damage to the circuit board.
After the power of the lithium battery in this product is empty, it cannot be used immediately after installation in the dry battery. It requires waiting for a while.