amazon basics B0186K8T90 Digital Luggage Scale User Guide

B0186K8T90 Digital Luggage Scale
User Guide

Important Safety Instructions

Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.

When using electrical products, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:

• This product contains no user serviceable parts and requires little maintenance. Leave any servicing or repairs to qualified personnel only.
• Do not attempt to repair the product yourself. In case of malfunction, repairs are to be conducted by qualified personnel only.
• Do not open the product housing. Do not insert any foreign objects into the inside of the housing.

Battery Warnings
Danger Risk of explosion!
Risk of explosion if the battery is replaced by an incorrect type.
Warning KEEP OUT OF REACH OF CHILDREN
Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours  of ingestion. Seek medical attention immediately.

• Keep batteries out of the reach of children. Especially keep batteries which are considered swallowob/e out of the reach of children. In 1:ose of ingestion of a cell or battery, seek medico/ assistance promptly.
• Do not allow children tc, replace batteries without adult supervision.
• Always insert batteries ,correctly with regard to polarity(+ and -I martced on the battery and the equipment. Batteries which are lnco”ectly placed Into equipment may be short-drcuited, or charged. This can result in a rapid tempetauu« rise causing venting, leakage and explosion and may cause personal injury.
• Do not short-circuit batteries. When the positive(+) and negative(·) terminals of a battery are in electrical contact with each other, the battery becomes short­ circuited. For example lo<>se batteries in a pocket with keys or coins, can be shott-circuited. This can result in venting. leakage, explosion, fire and personal injury.
• Do not charge batteries .. Attempting to charge o non­ rechorgeob/e (primary) b,ntery con cause internal gas and/or heat generation r!sulting in leakage, venting, explosion, fire and personal injury.
• Do not force discharge batteries. When batteries are force discharged by means of an external power source, the voltage of the battery will be forced below its design capability and gases will be generated inside the battery.
• This con result in leakage; venting, explosion, fire and personal injury.
• Exhausted batteries should be immediately removed from equipment and pmperly disposed of. When discharged batteries ore kept in the equipment for o long time electrolyte leakage can occur causing damage to the equipment and/or persor.,al injury.
• Do not expose batteries to heat. When a battery is exposed to heat venting, leakage and explosion may occur and cause personal injury.
• Do not weld or solder directly to batteries. The heat from welding or so/derin!I directly to o battery may cause internal short-circuiting l’esulting in venting, leakage and  explosion and may cause personal injury.
• Do not dismantle batteries. When a battery is dismantled or token apart, contact with the components con be harmful and con co11se personal injury or fire.
• Do not deform batteries. llotteries should not be crushed, punctured, or othE•rwise mutilated. Such abuse con cause leakage, venting, explosion or fire and con cause personal injury.
• Do not dispose of batteries In fire. When batteries ore disposed af in fire, the heat build-up con cause explosion and/or fire and personal inj’ury. Do not incinerate batteries except for opprov11d disposal in o controlled incinerator.
• A lithium battery with a damaged container should not be exposed to water. Lithium metal in contact with water con produce hydrogen gos, fire, explosion and/or cause personal injury.
• Do not encapsulate and/or modify batteries. Encapsulation, or any other modification to a battery, may result in blockage of the pressure relief vent mechonism(s) and/or prevent removal of hydrogen gos generated in the batteries.
• This may lead to explosion and personal injury. Advice from the battery manufacturer should be sought if it is considered necessary to make any modification.
• Store unused batteries in their origin.ii packaging away from metal objects. H already unpacked, do not mix or jumble batteries. IJ’npacked batteries could get jumbled or get mixed with metal objects such as keys, coins, etc. This con cause b11ttery short-circuiting which con result in leakage, venting, explosion or fire, and personal injury. One of the best ways to prevent this from  happening is to store unumf batteries in their original packaging.
• Remove batteries from equipment if it is not to be used for an extended pe,riod of time- unless it Is for emergency purposes.. it is advantageous to remove batteries immediately irom equipment which hos ceased to function satisfactorily. or when a long period of disuse is anticipated (e.g. portol1le lighting, toys). Although most batteries on the market today are provided with protective jackets or otner meons to amtain leakage, a battery that hos been partially or completely exhausted may be more prone to leak than one that is unused.
• When incorporating a primary lithium battery into a memory back-up circuit protective measures should be used to prevent the main power source from charging the battery. One method that has been shown to be effective is illustrated below.
• Connecting cells/batteri, is in parallel could result in charging one of the cells and cause leakage and potential cell rupture. Diode protection may be required depending upon the cell type. Device designers should contact the manufacturer for guidance.

Symbol explanation
This symbol stands for “Conformite Europeenne”, which declares “Conformity with EU directives, requlations and applicable standards”, With the CE­ marking, the manufacturer confirms that this product complies with applicable European directives and regulations.
** This symbol stands for “United Kingdom Conformity Assessed”. With the UKCA­ marking, the manufacturer confirms that this product complies with applicable regulations and standards within Great Britain.
Intended Use**

• This product is intended for household use only.
• This product is intended to be used in dry indoor areas  only.

Instructions for Use

• Always select the correct size and type of battery most suitable for the intended use. Information provided with  the appliance to assist correct battery selection should be retained for reference.
• Replace au batteries of a set at the same time.
• Clean the battery and appliance contacts prior to battery installation.
• Ensure that the batteries are installed correctly with regard to polarity(+ and-).

Buttons

| Switch on/off, Zero/Tare
---|---
| Weight unit conversion

Operation

Weight unit conversion
To toggle between kg and lb weight units, simply press the UNIT button on the LCD displc1y when it shows zero.
Weighing

1. Strap the webbing belt through the luggage handle and secure the hook of the bett onto the triangle ring.

2. Press the button to SWitch on the scale before lifting (ensure no stress).

3. When the LCD shows zero, lift the scale gently. Make sure the scale is horizontal and balanced. The LCD shows the weight of the luggage.
   Press the button to zero or tare weight before locking (if the weight is less than 2 kg, press the button to zero weigh1t. If the weight is more than 2 kg, press the button to tare weight (LCD shows n. The weight reading will be locked after flashing three times. LCD shows H. Press the button to reset the LCD to zero and enter the weighing mode again. The scale will display the weight reading for 2 minutes and automatically switch off.

4.  In weighing mode, press the button for 3 seconds to switch off.

Battery replacement

• Take out the used battery with the aid of an object with a pointed end, as shown in the illustration.
• Install the new battery by 1Jlacin9 one side of the battery beneath the battery baffle and then pressing down the other side (pleas,e observe the polarity).

Warning indicators

1. Replace the battery.
2. Scale overtoad. Remove the item to avoid damage. The maximum weight capacity is indicated on the scale.

 Cleaning and Maintenance

Notice:

• Switch the product off before cleaning.
•  During cleaning do not immerse the electrical parts of the product in water or other liquids. Never hold the  product under running water.

Cleaning

• To clean the product, wi1>e with a soft, slightly damp cloth.
• Wipe the product dry after cleaning.
• Never use corrosive dete1rgents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product

Storage
Store the product In its original packaging in a dry area. Keep away from children and pets.
Maintenance

• Any other servicing than mentioned in this manual should be performed by a professional repair centre.
• Do not stress the triangle ring for a long time. Keep the scale away from objects that could potentially switch the scale on and consume battery power.
• To ensure accuracy, do net use the scale In a strong  magnetic field.

Disposal (for Europe only)
The Waste Electrical and Electronic Equipment (WEEE) laws aim to minimise the impact of electrical and electronic goods on the environment and human health, bJ/ increasing re-use and recycling and by reducing the amount of WEEE going to landfill. The symbol on this product or ts packaging signifies that this product must be disposed separately from ordinary household wastes at ill; end of life. Be aware that this is your responsibility to dispose of electronic equipment at recycling centres in order to conserve natural resources. Each country should have its collection centres for electrical and electronic equipment recycling. For information about your recycling drop off area, please contact your related electrical and electronic equipment waste management authority, your local city office, or your household waste disposal service.
Battery Disposal
Do not dispose of used batteries with your household waste. Take them to an appropriate disposal/ collection site.

Specifications

Fur EU
Postal| Amazon EU S.a r.l.
38 avenue John F.
Kennedy, L-1855 Luxembourg
Business Reg.| 134248
Fc1r UK
Postal| Amazon EU SARL, UK Branch
1 Principal Place, Worship St, London EC2A 2FA,
United Kingdom
Business Reg.| B:R017427

Feedback and Help
We would love to hear your feedback. To ensure we are providing the best customer experience possible, please consider writing a customer  View .

amuon.co.uk/reviN1/revlew-your-purchases#
If you need help with your Amazon Basics product, please use
the website or number below .
amuon.co.uk/gp/help/customer/contatt-us
amazon.com/.r,mazonBasics
MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>