LAUFEN H2200870000001 Take Marbond Instruction Manual
- June 16, 2024
- LAUFEN
Table of Contents
Bathtubs
Art.-Nr. 2.2008.7.000.000.1
This instruction must be given to the user.
Guarantee/Liability only when assembled by an approved specialist in
accordance with the instructions and local regulations.
Installation instructions
Instructions for use
These instructions for use must be carefully read before installation.
Check on content of delivery and condition of the components
Check delivery after receipt for completeness and possibly damage (see parts
list).
Inform the dealer immediately when damage is apparent. We are not liable for
damage arising during or after installation/fitting.
Check door width before starting work:
Does the product fit through the door of the room, in which it will be
installed? Required minimum door width: See dimensions.
Lifting/moving: Only lift/move the tub using the transport straps supplied – never use the hoses or installation parts.
Laying circuits: Do not lay any circuits under the bath.
Protection from damage: Use suitable protective covers to prevent damage to surfaces and blockages by dirt or dust arising during fitting. Temporarily apply a protective cover to sensitive components (drain, nozzles, operating element) before starting installation.
Special precautions: When cleaning the tiles, make sure that no ammoniac or a similar aggressive cleaning agent come into contact with the installed parts.
Water inlet via hydromassage or overflow:
The connection must always be made by a qualified specialist.
Feed rate:
Maximum 20 litres/min (EN 200)
Overflow rate:
Minimum 36 litres/min (EN 274)
Drainage rate:
Minimum 48 litres/min (EN 274)
Checking that the tub is waterproof: After connecting the water supply
and drainage pipes, the tub must be filled and examined to ensure that it is
waterproof.
Subject to modifications: Laufen reserves the right to make changes or
product modifications without prior warning.
Dimensions mm
Parts list, tub assembly installation instructions
General Information, Maintenance Instructions
General instructions for use
Do not exceed 40 °C.
Drain the water after each use.
Never leave children unsupervised in the bath or shower tray.
Care instructions
The surface gathers hardly any dirt and is easy to clean and care for. For
regular cleaning we recommend: A sponge, soft cloth and some antistatic
cleaning agent. Rub down, if necessary, with a soft cloth. The surface is
dirt-repellent.
Avoid using scouring agents or solvents, which may damage the surface of the
shower tray.
Remove heavy dirt with liquid household cleaner e.g. dishwash detergents or
liquid soap (observe dilution instructions). Always rinse with plenty of clear
water and buff up with a cloth. Do not use any acidic cleaning agents or
vinegar-based cleaning agents.
Damage
Scratched surfaces should always be treated by a specialist. Serious damages
can be repaired with the maintenance kit (2.9996.5.###.000.1).
Damage resulting from inappropriate treatment by the user will not be covered by our guarantee.
Use
Beware! Increased risk of slipping when surface is wet. This is particularly so when using soap, shampoo, bath oil, etc.
CE Declaration of performance
We,
Laufen Bathrooms AG,
Postfach 432,
CH-4242 Laufen on our own responsibility, hereby declare that the Lua visions
of Construction Products Regulation (EU) 305/2011, comply with the following
standards:
EN 14516, 232
The declaration of performance DOP 14516 can be found on our website.
Laufen Bathrooms AG
Wahlenstrasse 46
CH-4242 Laufen, Switzerland
www.laufen.com
01/09/22 H2.9908.2.000.000.1 PLU
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>