homelabs HME010231N 79L Automatic Stainless Steel Kitchen Bin User Manual

Automatic
Trash Can
13 or 21 Gallon

HME010231N
HME010233N

Thank you for purchasing our appliance. Please be sure to read the entirety of this user manual carefully prior to using this appliance. If you have any questions regarding the use of this product, please call 1-(800)-898-3002.
In the event this product malfunctions, or you believe it is defective, please contact Customer Service at homelabs.com/help, 1-(800)-898-3002 or help@homelabs.com and hold onto the defective product (pending further instruction). A defective product should be clearly marked or stored where it cannot be used by mistake. Failure to keep the product in its original quality from the time of receipt may impede hOmeLabs’s ability to correct any legitimate problem and may limit the extent to which hOmeLabs may provide recourse.

Congratulations on bringing home your new appliance!
Don’t forget to register your product at homelabs.com/reg for updates, coupons, and other relevant information.
Although greatly appreciated, product registration is not required to activate any warranty.

Important Safety Instructions

This symbol indicates the possibility of death, injury, or property loss.
**** This symbol indicates that information is available such as the operating manual or installation manual.

When using your hOmeLabs Automatic Trash Can (appliance), basic safety precautions should always be followed to reduce the risk of electrical shock, and/or injury to persons. Incorrect operation due to ignoring instructions may cause harm or damage.

• Make sure there is enough room to operate the Trash Can without blocking the end of the Lid.

• Do not press or force the Lid of the Trash Can to close when it is open. Let it close by itself.

• Only use hOmeLabs power adapter model HME010246N with an output of 5.9 V / 500 mA.

• To prevent battery leak that potentially causes damage to the electronic components, remove batteries if the unit is not intended to be used for a long time.

• Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.

• Only use batteries of the same or equivalent type as recommended in the “Battery Replacement” instructions.

• Do not recharge the non-rechargeable batteries.

• Never short circuit the battery terminals.

• Avoid direct sunlight onto the infrared Sensor Ball.

• Ensure the Sensor Ball is kept clean for normal function.

• Do not use solvents or other chemicals to clean.

• Do not immerse the Lid Cover in water because it is equipped with electronic components.
  You can clean it with a damp cloth.

• Do not use the appliance for anything other than its intended use.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance

WARNING

• Risk of explosion if the battery is replaced by an incorrect type.
• All batteries should be replaced at the same time. Mixing old and new batteries in the device can lead to battery leakage and device damage.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

Important information for correct disposal of the product in accordance with EC Directive 2012/19/EU.
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossedout wheeled dustbin.

DISPOSAL
Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary.
It is prohibited to dispose of this appliance in domestic household waste.
For disposal, there are several possibilities:

1. The municipality has established collection systems where electronic waste can be disposed free of charge.
2.  As old products contain valuable resources, they can be sold to scrap metal dealers.

Wild disposal of waste in forests and landscapes endangers your health. Hazardous substances leak into the groundwater and find their way into the food chain.

RoHS Compliance
This product is in compliance with directive 2011/65/EU of the european parliament and of the council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment.

SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY

Parts Description

This Trash Can uses 4 “C” (LR14/AM2) alkaline batteries (not included).

Operation

OPERATING INSTRUCTIONS
The hOmeLabs Touchless Trash Can uses infrared (IR) technology with an Infrared Sensor on the Lid to sense movement. When movement is detected, such as with a hand waving within 15 cm (6 inches) of the IR Sensor, the Lid will automatically open. When no more movement is detected, about 6 seconds after your hand moves away, the Lid will automatically close. The Lid remains open whenever movement is detected within 15 cm (6 inches) of the IR Sensor zone.

TO REPLACE BATTERIES

1. Locate the Battery Cover on the bottom of the Trash Can (See > Page 7).
   Press both Battery Cover Tabs to remove the Battery Cover.

2. Remove the used batteries and dispose of them properly.

3.  Insert 4 new “C” (LR14/AM2) alkaline batteries (not included) as indicated inside the battery compartment.

4. Replace the Battery Cover.

NOTE: Depending on battery make and capacity, 4 new “C” cell alkaline batteries should last for around 3 months.
OPERATING INSTRUCTIONS
• Confirm you received all parts before using the Touchless Trash Can.
• Follow the “To Replace Batteries” steps to install 4 new batteries.
• Place your empty garbage bag inside the Can Body. Wrap the top of the bag over the Can Body.

1. Insert the Plastic Bracket with its Smart Retainer Rings onto the Can Body, over the inserted garbage bag. Leave the Rings up. (See Figures 1–2)
2.  Pull up the garbage bag edges. Fold the bag edges inside the Can – over the Plastic Bracket and under the Rings. (See Figure 3)
3.  Fold down the Smart Retainer Rings to hold the bag in place. (See Figure 3)
4.  Once complete, place the Lid on top. The sensor and buttons should face the front of the Can Body. (See Figure 4)
   • Adjust the Sensor Direction.
   • Rotate the 90° swiveling Sensor Ball to select the sensor direction: TOP or SIDE.
   NOTE: To ensure normal operation, always keep the Sensor Ball clean.
   • Turn on the power switch located at the rear of the Lid Cover.
   • A RED indicator light will flash once. It will then flash once every 5 seconds. The system is now activated and in Standby Mode.
   • You may now open the Lid either automatically, by waving your hand about 15 cm (6 inches) from the Infrared Sensor or by pressing the “Open” button manually.

TO OPEN / CLOSE
Automatically

• Wave your hand near the sensor within 15 cm (6 inches) to open the Lid.
• The Lid will close automatically about 6 seconds after no movement occurs.

Manually

• Press the “Open” or “Close” button on the Lid.

NOTE: If you press the “Open” button, the Lid will open and remain open for 6 minutes. It will then close automatically. To close before 6 minutes, press the “Close” button. The Trash Can will resume operating in Automatic Mode (touchless).
DO NOT PRESS THE LID! Always press the “Close” button to manually close the Lid.

TO SYNC LID COVERS
If only one Lid Cover lifts up, the gears inside are out of sync on the opposite Cover (that is not lifting).
To adjust/sync them:

• Flip the Lid to examine the gears.
• If 1 tooth is displaced when tilted: Click, level, and align the covers.
• If 2 teeth are displaced: Push the upper plate twice. You’ll hear a clicking sound twice.
• Once the gears are synched, flip the Lid over and set it on the Trash Can.
• Test the touchless function by waving your hand about 15 cm (6 inches away from the Sensor.

ABOUT INDICATOR LIGHTS

• Standby Mode – indicator light will flash every 5 seconds
• Manual/Automatic Opening – all 6 indicator lights will turn red simultaneously
•  Time to Change the Batteries – all 6 indicator lights will repeatedly flash together every second

How the Smart Retainer Ring Works:

Warranty

hOmeLabs offers a limited one-year warranty (“warranty period”) on all of our products purchased new and unused from hOmeLabs Technologies, LLC or an authorized reseller, with an original proof of purchase and where a defect has arisen, wholly or substantially, as a result of faulty manufacture, parts, or workmanship during the one-year warranty period. The warranty does not apply where damage is caused by other factors, including without limitation to: (a) normal wear and tear; (b) abuse, mishandling, accident, or failure to follow operating instructions; (c) exposure to liquid or infiltration of foreign particles; (d) servicing or modifications of the product other than by hOmeLabs; (e) commercial or non-household use.
The hOmeLabs warranty covers all costs related to restoring the proven defective product through repair or replacement of any defective part and necessary labor so that it conforms to its original specifications. A replacement product may be provided instead of repairing a defective product. hOmeLabs’s exclusive obligation under this warranty is limited to such repair or replacement.
A receipt indicating the purchase date is required for any claim, so please keep all receipts in a safe place. We recommend that you register your product on our website: homelabs.com/reg. Although greatly appreciated, the product registration is not required to activate any warranty and product registration does not eliminate the need for the original proof of purchase. The warranty becomes void if attempts at repair are made by nonauthorized third parties and/or if spare parts, other than those provided by hOmeLabs, are used. You may also arrange for service after the warranty expires at an additional cost.
These are our general terms for warranty service, but we always urge our customers to reach out to us with any issue, regardless of warranty terms. If you have an issue with a hOmeLabs product, please contact us at 1-(800)-898-3002, and we will do our best to resolve it for you.
This warranty gives you specific legal rights, and you may have other legal rights which vary from state to state, country to country, or province to province. The customer may assert any such rights at their sole discretion.

Manufacturing Info
This manual covers all items with these model numbers:

HME010231N
HME010233N

Warning
Keep all plastic bags away from children.
Contact Us

homelabs.com/help| 1-(800)-898-3002| help@homelabs.com

For Household Use Only
Imported by Xtava, LLC
Unit 8, Shakespeare Industrial Eastate,
Watford, Herts, WDR24 5RY
Distributed by hOmeLabs™, LLC
37 East 18 Street, 7th Floor
New York, USA 10003
1-(800)-898-3002
help@homelabs.com
homelabs.com/help
All rights reserved, hOmeLabs™.
Made in China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>