weeylite 3.5 x 3.5 Inch Rounded Matte Black Door Hinges Instruction Manual
- June 16, 2024
- weeylite
Table of Contents
weeylite 3.5 x 3.5 Inch Rounded Matte Black Door Hinges
- 3.5 Inch x 3.5 Inch Door Hinges
- Standard size rounded full mortise butt hinges
- Made of quality steel construction
Finish
- Matte Black
- Satin Nickel/ Brushed Nickel
Tools required for door mounting
Steps to install the door
Caution!
- This product contains small items that may pose a choking hazard if swallowed. Please keep these items away from young children.
- Looking to install or remove door hinges on your doors? Home DIY mode follow these easy steps to get the job done (If you are unsure of any part of this installation, please contact a professional installer for assistance.):
- Gather the necessary tools: You’ll need a screwdriver, lap ruler, marker pen, a hammer, goggles and a chisel.
- Start by closing the door to keep it from falling when you remove the pins or screws.
- Have someone help you hold the door in place, especially if you are dealing with heavy wooden doors that can cause damage or injury if they accidentally fall.
- Pro tip: Try sliding a block of wood in the space underneath the door for support.
- Remove the old hinges: Use a screwdriver to unscrew the old hinges from the door and the door frame. Remove the old lockset and hinge pins and take out the door. Remove the hinge plates from the door as well.
Determine the location of the hinge on the door and the frame. Hold the door in place and use a pencil to mark where the hinge will be installed on both the door and the frame. Drill pilot holes for the screws using a drill bit that is slightly smaller than the screws. The pilot holes will prevent the wood from splitting when the screws are inserted. Install the hinge on the door using the screws provided. Make sure the hinge is flush with the edge of the door and that it is level.
Hold the door in place and align the hinge on the frame with the hinge on the door. Use a pencil to mark where the hinge will be installed on the frame. Drill pilot holes for the screws on the frame using a drill bit that is slightly smaller than the screws. Install the hinge on the frame using the screws provided. Make sure the hinge is flush with the edge of the frame and that it is level. Test the door to make sure it opens and closes smoothly. If necessary, adjust the by loosening the screws and repositioning the hinge.
If you’re looking to fix a loose or damaged hinge, you may want to consider using a door hinge repair kit. Follow these steps to use a typical kit: Remove the door: Take the door off its hinges and lay it flat on a stable surface. Remove the hinge pin: Use a hammer and a nail to tap the hinge pin out of the hinge. Insert the hinge pin into the repair kit: Place the hinge pin in the hole in the repair kit and screw it in place.
Reinstall the hinge: Put the hinge back on the door and screw it in place. With these easy steps, you’ll be able to install or repair your door hinges in no time. The primary use of hinges is to allow doors, windows, gates, and other objects to open and close easily and smoothly. They also provide stability and support, preventing objects from falling or sagging. In addition, hinges can be used to adjust the angle of an object or to secure it in place.