Kaigelin LEDs Light LED Solar Ground Spot Instruction Manual
- June 4, 2024
- Kaigelin
Table of Contents
Art.nr: 1000435
Solar path lighting puck- RGB
Instruction Manual
LEDs Light LED Solar Ground Spot
Introduction
Please read this instruction carefully before use.
Initial charging:
If the solar panel is covered with a thin protective film, remove it before
using the product. Remove the ground spike by holding the solar unit firmly
and turning the ground spike counterclockwise, as shown in fig.1, and remove
the pull tab from the battery compartment. Replace the ground spike, and turn
it clockwise to lock it. (fig.2) Place the product in a location where it can
receive a full 8 hours of sunlight to allow the rechargeable battery to reach
maximum capacity.
Optimal location for charging:
Place the product in an area where it can receive direct sunlight for at least
8 hours each day. Shadowed locations will not allow the battery to charge
fully and will reduce the hours of nighttime lighting. The selected location
should not be near nighttime light sources, such as porch lights, street
lights, or pool lights, as these may cause the solar light to turn off
prematurely.
operation
This product has two distinct modes of operation, selectable by means of the mo-de-switch (A) the mode switch has three positions:
- OFF – turns the device off, it will not light at all
- ON – when darkness falls, the product will start to spread a warm white light (2.700K)
- RGB – when darkness falls, the product will start to slowly phase through all the colors of the rainbow, gently flowing from one to the other. When fully charged, the product will light up for 6-8 hours.
Battery Replacement:
NOTE: This operation should be done in the morning on a sunny day. This
will allow the product to receive a full 8 hours of sunlight so that the
rechargeab-le battery can reach maximum capacity.
-
Remove the ground spike by turning it counterclockwise. (Fig.].)
-
Remove the old battery and replace it with a new AAA size 1.2V rechargeable battery of the same or greater capacity (mAh). (USE RECHARGEABLE NiMH (HR03) BATTERIES ONLY!)
Note: Clean the battery contacts and those of the device prior to battery installation. -
Be sure to insert the battery in the proper direction (+/-).
-
Replace the ground spike on the solar puck. (Fig.2)
Warning
- Safe for outdoor operation.
- Failure to insert the battery in the correct polarity, as indicated in the battery compartment, may shorten the life of the battery or cause the battery to explode or leak.
- Do not dispose of batteries in a fire.
- Batteries should be recycled or disposed of as per the manufacturer’s recommendations.
- Remove the battery if consumed or if the product is to be left unused for a long period.
Care and Cleaning
Solar panels should be cleaned periodically with a damp cloth for maintaining
optimum performance (to remove dust and debris). Do not place in areas where
children nor-mally play, or where they may trip and fall against the solar
lantern.
Notes on Disposal
The product is designated for separate collection at an appropriate collection
point. Do not dispose of the product with household waste. For more
information, contact the retailer or the local authority responsible for waste
management.
Care
Before cleaning the unit, disconnect it, if necessary from other components; do not use aggressive cleaning agents. The unit has been carefully checked for defects. If nevertheless, you do have cause for complaint, please go back to the retailer where you have bought the product together with your proof of purchase. We are not liable for damage arising from incorrect handling, improper use or wear or tear. We reserve the right to make technical modifications.
Safety
General Safety
- Read the manual carefully before use. Keep this manual for future reference.
- Only use the product for its intended purposes. Do not use the product for other purposes than described in the manual.
- Do not use this product if any part is damaged or defective. If the product is damaged or defective, replace the product immediately.
- This product shall not be used by children without the supervision of an adult. Children shall not play with the device.
- Do not modify the product in any way.
- Do not expose the product to water or moisture. (IP 20)
- Do not immerse the product in water. (IP 44 – IP 67)
- Keep the product away from heat sources.
- Do not block the ventilation openings.
- Do not look directly into the LED lamp.
- Keep a minimum distance of 1 meter between the lamp and the surface being illuminated.
MV#: 20191029 09:30 Nederland –www.shada.nl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>