BOSCH AP-N02 Cabin Filters Installation Guide

Bosch
Installation Guidelines for Cabin Filters

AP-N02 Cabin Filters

Part Number: AP-N02
0986 AF7 005

This manual describes how to replace the cabin filter. Before installing, please be sure to read this book to ensure safe and correct installation.
Estimated Installation Time: 5-10 minutes
In some cases, tools are required and replacement work adds additional time.
Recommended replacement time
1 year or 10,000km
However, it is recommended to check and replace your cabin filter as soon as possible when driving in heavily soiled areas.
The contents of this installation guide are accurate as of May 2022

Precautions for installation and use

• Be sure to park your vehicle in a safe place with the engine and air conditioner turned off before commencing the replacement process.
• When replacing your cabin filter, please refer to the instruction manual of the vehicle, maintenance manual, etc.
• This guide is just an example and may differ from the actual vehicle.
• Please refrain from unreasonable work. It may result in damaging the vehicle or personal injury.
• If you are not confident in the work please consult your local workshop.
• Check the direction of the arrow so that you do not mistake the front and back of the filter when installing.
• This product displays AIR FLOW (wind direction) with an arrow, but other companies may display “TOP UP” on their filters.

N02 Cabin Filter Installation Guide

Type 1
1. Removing the glove box

1. Open the glove box, remove the pins ( 2 places) from the inside
2. Remove the glove box

2. Removing the old filter

1. Remove the claws (2 places) of the cabin filter cover by pulling it towards you
2. Remove the old cabin filter

3. Installing your Bosch cabin filter

1. Insert the Bosch cabin filter with the “AIR FLOW” arrow pointing down
2. Restore the removed vehicle parts to their original positions

Type 2
1. Removing the glove box

1. Remove the claws (2 places) on the lower panel.

2. Remove the scuff plate.

3. Remove the plastic nut (1 place) and claws (2 places)

4. Remove the side panel in the direction of the arrow.

5. Remove the screws (6 places) and pull the panel towards you to remove it.

2. Removing the old filter

1. Remove the hook on the left side of the filter cover
2. Remove the filter cover by pulling in the direction of the removal arrow

1. Remove the claws (2 places) of the cabin filter cover by pulling it towards you
2. Remove the old cabin filter

3. Installing your Bosch cabin filter

1. Insert the Bosch cabin filter with the “AIR FLOW” arrow pointing down
2. Restore the removed vehicle parts to their original positions

Attention

• This work procedure is an example and may vary across different vehicles.
• Bosch’s cabin filter indicates airflow with an arrow on the product. Please note that the arrow may indicate “TOP” on other genuine or !AM products.
• Please read the “Precautions for installation and use” on the installation guide cover be- fore commencing.
• NOTE: used cabin filters cannot be cleaned and reused.

Robert Bosch (Australia) Pty. Ltd.
1555 Centre Road
Clayton VIC 3168
For Further information please contact Bosch on:
Email: [email protected]
Australia: 1300 307 040 www.boschaftermarket.com.au
New Zealand 0800 452 896 www.boschaftermarket.co.nz

References

• Invented for life | Bosch Global
• Home | Bosch Mobility Aftermarket in Australia and New Zealand
• Home | Bosch Mobility Aftermarket in Australia and New Zealand

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>