SMAVISTA OS010 Permanent Outdoor Lights User Manual

SMAVISTA OS010 Permanent Outdoor Lights User Manual

Customer Service

具Warranty: 36-Month Limited Warranty

Support: Lifetime Technical Support

Email: [email protected]

FCC and ISED Canada Statement

This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help..

FCC and IC Radiation Exposure Statement

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator &your body.

la distance entre utilization et apparel ne droit pas ere in 20 cm.

This device uses a non-replaceable light source. When the light source reaches the end of its life cycle, this device should be replaced.

Not intended for illumination. Only used for creating ambiance.

1. Do not connect the rope light to the supply while it is in the packing or wound onto a reel;
2. Do not use the rope light when covered or recessed into a surface;
3. Do not open or cut the rope light;

Responsible party:
Name: Dongguan Yongming Lighting Co., Ltd.
Address: Room 304, Building 3, No.82 Bahu Road, Sieging Town, Dongguan
Email:  [email protected]

READ AND SAVE THESE INSTRUCTIONS

Safety Instructions

• This product is rated as IP67 Waterproof it can be used outdoors but be immersed in water is not recommended.
• The control box and power adapter are both rated as IP65. They can be used outdoor but cannot be immersed in water,
• To prevent the light string from falling down,ensure it is installed with both the adhesive tape and the clips.
• Tighten up the waterproof cap before using the light.
• Do not allow children to assemble and install this product.
• Avoid installing this product near major heat sources or other dangerous sources.
• Avoid using other non-standard adapters for this product.
• External dimmer cannot be used with this product.
• Use this product with the provided power adapter only.

What You Get

At a Glance

a. Power Adapter
b. Control Box
c.   Permanent Lights
d. Waterproof Connector

• Press to turn on or off.
• Press and hold for 5 seconds to reset.

Pairing Your Light with Amazon Alexa and Google Home App

What You Need
AWI-Fi router supporting the 2.4GHz and 802.11 b/g/n bands. 5GHz is not supported.

**Smartphone or tablet running iOS 8.0 (or above)or Android 4.3 (or above)

**

1. Regardless of whether your phone uses IOS or Android, you can download the Amazon Alexa or Google Home app to connect to this permanent outdoor light.
2. Download Google Home app from the App Store (IOS devices) or Google Play (Android devices).

Q Tap the device icon and follow the on-screen instructions to complete pairing.

Controlling the Light with Your Voice

1. Open the app, then tap the device icon to enter the details page.
2. Tap the setting icon in the top right corner.
   @ Select Using Guidance and follow the on-screen instructions to control the device using your voice.

Specifications

Troubleshooting

0 The adhesive tape is not strong enough.
Use the clips to secure the strip lights firmly during installation.

@The light do not display the selected color fully/Some LED beads do not light up.

Please contact the SMAVISTA support team to obtain quick products replace

Cannot sync the light to the beat of my music.
a. Move the control box closer to the music source
b. Clean the mic on the control box then try again.

Cannot connect to Wi-Fi
a. Do not skip the ‘Wi-Fi connecting steps in the app.
b. 5GHz network is not supported. Please set the router to 2.4GHz and then reset it.
c. Connect your smartphone to Wi-Fi and check whether the network works well.
d. Make sure you have entered the correct Wi-Fi name and password.
e. Change your Wi-Fi password to a brief one.8 numbers and letters are suggested
1. Connect hotspot in your phone to the lights and check whether the router works with the lights.

Cannot connect to Alexa.
a. Pull out every connective part of the lights and firmly re-connect them
b. Re-connect your smartphone to Wi-FL
c . Plug out the adapter port and re-plug it in

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>