Whirlpool WTS4445 A+NFX Aqua Fridge-Freezer Instructions Manual
- January 2, 2024
- Whirlpool
Table of Contents
Whirlpool WTS4445 A+NFX Aqua Fridge-Freezer
BEFORE USING THE APPLIANCE
Your new appliance is designed exclusively for domestic use.
To ensure best use of your appliance, carefully read the operating
instructions which contain a description of the product and useful advice.
Keep these instructions for future reference.
1. After unpacking the appliance, make sure it is not damaged and that the
door closes properly. Any damage must be reported to the dealer within 24
hours of delivery of the appliance.
2. Wait at least two hours before switching the appliance on, to ensure that
the refrigerant circuit is fully efficient.
3. Installation and the electrical connection must be carried out by a
qualified technician according to the manufacturer’s instructions and in
compliance with the local safety regulations.
4. Clean the inside of the appliance before using it.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packing material is 100% recyclable and bears the recycling symbol. For
disposal, comply with the local regulations. Keep the packing materials
(plastic bags, polystyrene parts, etc.) out of the reach of children, as they
are a potential source of danger.
2. Scrapping/Disposal
The appliance is manufactured using recyclable material.
This appliance is marked in compliance with European Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE). By ensuring the correct
disposal of this appliance, you can help prevent potentially negative
consequences for the environment and the health of persons.
The symbol on the appliance, or on the accompanying documents, indicates that
this appliance should not be treated as domestic waste but must be taken to a
special collection centre for the recycling of electrical and electronic
equipment.
When scrapping the appliance, make it unusable by cutting off the power cable
and removing the doors and shelves so that children cannot easily climb inside
and become trapped.
Scrap the appliance in compliance with local regulations on waste disposal,
taking it to a special collection centre; do not leave the appliance
unattended even for a few days, since it is a potential source of danger for
children.
For further information on the treatment, recovery and recycling of this
product, contact your competent local office, the household waste collection
service or the shop where you purchased the appliance.
Information:
This appliance does not contain CFCs. The refrigerant circuit contains R134a
(HFC) or R600a (HC) (see the rating plate inside the appliance). Appliances
with Isobutane (R600a): isobutane is a natural gas without environmental
impact, but is flammable. Therefore, make sure the refrigerant circuit pipes
are not damaged.
This product may contain Fluorinated Greenhouse Gases covered by the Kyoto
Protocol; the refrigerant gas is inside a hermetically sealed system.
Refrigerant gas: R134a has a Global Warming Potential of (GWP) 1300.
Declaration of conformity
This appliance has been designed for preserving food and is manufactured in compliance with Regulation (CE) No. 1935/2004.
This appliance has been designed, manufactured and marketed in compliance
with:
– safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces
73/23/CEE and subsequent amendments);
– the protection requirements of Directive
“EMC” 2004/108/EC.
Electrical safety of the appliance can only be guaranteed if it is correctly connected to an approved earthing system.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
INSTALLATION
The appliance must be handled and installed by two or more persons.
Be careful not to damage the floors (e.g. parquet) when moving the
appliance.
During installation, make sure the appliance does not damage the power
cable.
Make sure the appliance is not near a heat source.
To guarantee adequate ventilation, leave a space on both sides and above the
appliance and follow the installation instructions.
Keep the appliance ventilation openings free.
Do not damage the appliance refrigerant circuit pipes.
Install and level the appliance on a floor strong enough to take its weight
and in a place suitable for its size and use.
Install the appliance in a dry and well-ventilated place. The appliance is
arranged for operation in places where the temperature comes within the
following ranges, according to the climatic class given on the rating plate.
The appliance may not work properly if it is left for a long time at a
temperature outside the specified range.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>