KCT Direct PGT303 72pc Wall Mount Storage Bin Organiser Instruction Manual

Table of Contents

KCT-Direct-PGT303-72pc-Wall-Mount-Storage-Bin-Organiser-
product

Specifications

Mounting Preparation

Before mounting the storage unit, please follow these steps:

Ensure that you have a solid wooden base that can support the weight of the storage unit.
Inspect the mounting surface to ensure there are no hidden electrical wires, cables, or pipes.

Mounting the Perforated Boards

Follow these steps to mount the perforated boards:

Align the slots in the perforated panels so that the slots holding the containers are open on the top.
Hold the perforated boards against the surface where they will be mounted.
Use a spirit level to align the boards properly.
Mark the mounting holes on the surface.
After ensuring there are no potential wiring or piping obstructions, drill the mounting holes.
Mount the perforated boards securely to the wall using appropriate screws or fasteners.

Hanging Display Boxes

To hang the display boxes, follow these steps:

Note : Ensure that the unit is fully assembled and sturdy once assembly is complete.

FAQ

Q: What should I do if there are hidden electrical wires or pipes on the mounting surface?
A: It is important to inspect the mounting surface carefully before drilling any holes. If you find hidden electrical wires or pipes, it is recommended to seek professional assistance to safely mount the storage unit.
Q: What protective equipment should I wear during assembly?
A: It is important to wear appropriate protective equipment, such as gloves and safety goggles, during assembly as some parts may have sharp edges.

Mount on a solid wooden base that can support the weight when the
Inspect the mounting surface to make sure that there are no hidden electrical wires, cables or pipes.
Align slots in perforated panels so that the slots holding the containers are open on the top.
Hold perforated boards against the surface on which they are to be mounted and align them with the help of a spirit level.
Now set the mark for the mounting holes.
After checking the mounting surface for potential wiring etc. drill the mounting holes and then mount the perforated boards to the wall.
Hang display boxes from the perforated boards by gripping the rear lip of the display boxes and slotting them into the open slot of the perforated board.

$KCT-Direct-PGT303-72pc-Wall-Mount-Storage-Bin-Organiser-fig- $2$$

IMPORTANT

Please wear the appropriate protective equipment during assembly as parts may have sharp edges.
Ensure wall fixings are suitable for your wall surface/type.
Do not assemble if parts are missing or do not fit correctly.
Make sure the unit is fully assembled and sturdy once assembly is complete.

Imported by:
КСТ Leisure Glebe Farm, Old London RoadCopdock Ipswich, Suffolk IP8 3JN United Kingdom