SHOKS 9901 Keyless Entry Door Lock Installation Guide

**SHOKS 9901 Keyless Entry Door Lock Installation Guide

**

Installation Instruction

Tools required for installation

• Phillips Screwdriver
  

• Measuring Tape

• Electric Drill

• 2⅛” Hole Boring Saw

• 1″ Drill Bit

• ⅜” Drill Bit

Parts in the box

• Exterior Panel

• Handle

• Interior Door Lever

• Thumb Knob

• Dead Bolt

• Latch Bolt

• Striking Plate A (use for Dead Bolt)

• Striking Plate B (use for Latch Bolt)

• Striking Plate Box A (use for Dead Bolt)

• Striking Plate Box B (use for Latch Bolt)

• Fixing Ring

• Gasket

• Connecting Column

• Screw A(20mm) 8pcs

• Screw B(45mm) 2pc

• Screw C(35mm) 3pcs

• Hexagon Wrench

Drill Holes （For pre-drilled door, or replacement, please skip to Adjust

the Dead Bolt)

Note: Applicable door thickness: 35-45mm

Fold the template at the dotted line and tape the template to the interior side of the door at 36 to 38 inch Height.

• a. Mark the 2⅜ ”or 2¾”(60 or 70mm) hole center as A1 for the backset.
• b. Mark a point as A2, 5½” above A1 .
• c. Mark a point as C, about 9” below A1.
• d. Measure the thickness of the door and mark the middle point of the door thickness as B1.
• e. Mark a point as B2, 5½” above B1.

Note: Make sure the A1 and B1(A2 and B2) are at the same height.

• a. Drill two Dia. 2⅛”holes for the lock bodies at point A1 and A2.

• b. Drill two Dia. 1” holes for the latches at point B1 and B2.

• c. Drill a Dia. 3/8” hole for the connecting column at point C.

• a. Insert the latches into the holes and mark the outline of faceplates.

• b. Chisel 1/8” deep holes.
  

• a. Close the door with the latch installed and mark lines on the jamb as picture shown left.

• b. Align the striking plates with the lines. Draw the shape of striking plates.

• c. Drill 1” deep hole in the middle of the striking plates.

• d. Chisel 1/16” deep for the striking plates.

Adjust the Dead Bolt

The latch is initially set for 2⅜”(60mm). Switch to 2¾”(70mm), if your backset is 70mm.

• Pull the block to extend the tongue.

• Rotate 180°down
  

• Pull the block back to retract the tongue
  

Install the Latches and Striking Plates

Install Exterior Lock

• a. Secure the handle on the exterior panel with screw which fixed in the handle.
• b. Install the connecting column at the bottom of the handle.
• c. Loosen the lower screw to adjust the connecting column height if needed.
• d. Install the fixing ring.
• e. Insert the stem into the dead bolt and insert the spindle into the latch bolt.
  Ensure the dead bolt tongue is retracted.
  
  

Install Interior Lock

• a. Secure the thumb knob with Screw B. Ensure the stem is vertical.
• b. Secure the door lever with Screw C.
• c. Secure the gasket with Screw C.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>