HYLELE LED Area Parking Lot Light Installation Guide
- June 15, 2024
- HYLELE
Table of Contents
Installation Instructions of LED Area Light
LED Area Parking Lot Light
WARNING
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- Do not cover any part of the fixture; this can cause overheating.
- Do not use in areas that are not properly ventilated from strong fumes.
CAUTION: RISK OF INJURY
- Avoid direct eye exposure to the light source while it is on.
- Account for small parts and destroy packing material, as these may be hazardous to children.
- Suitable for Wet locations IP65.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK
- Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
- Turn off the power when you perform any maintenance.
- Verify that supply voltage is correct by comparing it with the luminaire label information.
- Make all electrical and grounded connections in accordance with the National Electrical Code and any applicable local code requirements.
- All wiring connections should be capped with UL approved wire connectors.
WARNINGS
A DISCONNECT POWER BEFORE A INSTALLING OR SERVICING ****
For Round Pole
- Tighten the bolt in a clockwise direction .
- SF brackets to suitable angle
- Make sure holes on the brackets are corresponding to the holes on the pole.
- Use the bolt and nut plate to fix the fixture to the pole.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>