Flosmore Telescopic Portable Water Flosser User Manual

Flosmore Telescopic Portable Water Flosser

Notes:

1. Lean low over sink and place the nozzle in mouth. Aim the tip toward gum line, and turn on the unit. For best results, start with the back teeth and work toward the front teeth. Glide tip along gum line and pause shortly between teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth. Direct the jet stream at a 90-degree angle to your gum line. Slightly close lips to avoid splashing but allow water to flow freely from mouth into the sink. Keep the unit upright during usage for best results.
2. The default mode is Normal (4 pressure settings: Soft/Normal/Pulse/Pause) when first use. You can adjust the pressure mode by short pressing the button. CY1000 water flosser can automatically remember the last pressure mode when you use it more than 3 seconds.
3. Auto shut-off turns off after 2min cycle is complete. It is recommended to run CY1000 water flosser for about 3 seconds to clear the internal excesss water.
4. A full charge will last for about 30 days of use. When the battery is in need of charging (approximately 30% reminder), the LED indicator will turn red and blink for reminder.

Warning
To reduce the risk of burns, electrocution, fire, or injury:

• Do not plug this device into a voltage system that is different from the voltage system specified on the device or charger.

• Do not direct water under the tongue, into ears, nose or other delicate areas. This product is capable of producing pressures that may cause serious damage in these areas.

• Do not direct water into nose or ear. The potentially deadly amoeba, Naegleria fowleri, may be present in some tap water or unchlorinated well water and may be fatal if directed into these areas.

• Do not direct water into nose or ear. The potentially deadly amoeba, Naegleria fowleri, may be present in some tap water or unchlorinated well water and may be fatal if directed into these areas.

• Use this product only as indicated in these instructions or as recommended by your dental professional.

• Pacemakers and similar implanted medical devices may be affected by the build-in magnets.

• Do not drop or insert any foreign object into any opening on the products.

• Keep charging unit and cord away from heated surfaces.

• Do not use iodine, saline (salt solution), or water insoluble concentrated essential oils in this product. Use of these can reduce product performance and shorten the life of the product.
  Use of these products may void warranty.

• Remove any oral jewelry prior to use of this product.

• Do not use it if you have an open wound on your tongue or in your mouth.

• This appliance is not intended for use by persons (including children with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsibility for their safety.

• Children should be supervised to ensure that they do not play with appliance.

CY1000 details

1. Nozzle (Separate pack)
2. Water outlet
3. Water inlet
4. Charging port
5. Water tank
6. Nozzle slap-fit
7. Power button
8. Pressure button
9. Mode indicator
10. Nozzle storage area
11. Power indicator

Getting started

Charging the Unit Prior to First Use
Connect the unit to the USB port of the power adapter (not included in accessories) with the provided charging cable. The LED indicator stays green and flashing until fully charged. It takes about 4 hours to fully charge the unit.

1. Rotate to open the top cover and take out the nozzle, then insert nozzle into the unit. Try to pull the tip out gently to confirm the tip is locked firmly.
2. Pull down the water tank to the bottom and fill water from top of the unit.
3. Press the switch button to select the mode for first-time use. Get a suitable working mode or as instructed by your dental professional.
4. Place the nozzle into your mouth and aim the nozzle towards the area to clean, then turn on power switch.

When finished

1. Empty any liquid left in the water tank.

   • Switch on and fill the water inside the appliance. Run the appliance for 2-3 seconds until no water comes out.

   • After using any special solution in the water tank, rinse it thoroughly.
     Partially fill the water tank with warm tap water. Aim the nozzle into your sink, and turn on the appliance and let it run until empty. This will help keep the nozzle from clogging and help your appliance and let it run until empty. This will help keep the nozzle from clogging and help your appliance to last longer.

   • Before exposing the appliance to freezing temperatures, run the water tank ompletely empty

2. Press the nozzle release button, remove the nozzle and place it in the storage.

3. Clean the product when necessary by using a soft cloth and mild non-abrasive cleanser.

4. Store the main unit.

Working modes

• Soft mode: Gently clean the teeth and gum line.
• Normal mode: Normal oral cleaning.
• Pulse mode: Effectively clean up the residue and plaque
• Pause mode: Press and hold on/ off switch button to work, release to stop working, press mode button to switch mode.

FAQS

How many times should I use CY 1000 water flosser daily?

Dental professionals recommend you to floss at least once per day and brush your teeth at least twice per day to maintain good oral health. You can floss more often if you need additional cleaning to treat gum diseases as directed by your dental professional.

Can I use mouthwash or other solutions in the CY1000 water flosser?

Mouthwash or other recommended antibacterial solutions can be used in your CY 1000 water flosser. We do not recommend mouthwashes or additives that contain iodine, peroxide, baking soda,or water-insoluble concentrated oils (such as Tea Tree Oil) because they may reduce the product performance and shorten the life of the unit (formulated products that are commonly available, such as Listerine, contain essential oils in small amounts and won't harm the product). We recommend using no more than a 1:1 ratio of solution to water. Any time an agent other than plain water is used in your CY 1000 water flosser, please flush the unit by running plain water through it afterward.

How often should the nozzle and hose be replaced?

It is recommended that the standard nozzle usually should be replaced every 6 months. The hose is designed to last long enough for your daily use. The add- on is for the unusual case that the hose falls off or wears badly, you may need an extra one in case of need.

How long will the unit last when the power is full?

A full charge will last for approximately 30 minutes. If you floss our teeth at medium pressure twice per day, your CY1000 water flosser can last for about two weeks when fully charged.

Specifications

• Model: CY1000
• Modes:  Soft, Normal, Pulse, Pause
• Pressure Range:  30-110PSI
• Battery Capacity:  2000mAh
• Water tank capacity:  200mL
• Input:  DC 3.7-5V, 10W
• Charging port:  Type C

Manufacturer
Shenzhen Ubee Technology Co., Ltd.
Support@flosmore.com
www.flosmore.com
Block 1, Geya technology building, Guangming, shenzhen, China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>