AIPER B0CHVXNRPM Seagull Pro Lite Cordless Robotic Pool Vacuum Cleaner User Manual

ROBOTIC POOL CLEANER
User Manual
Aiper Seagull Pro Lite

Important Safety Precautions

Please read this manual carefully and use your Aiper pool cleaner in accordance with the manual instructions. Aiper is not liable for any losses or injuries caused by improper use of this device.
For your safety and optimal! performance of this device, please read and follow the following suggestions.

1. Do not operate your Aiper pool cleaner while people or animals are in the pool.
2. Turn the cleaner off while not in use or while performing maintenance.
3. Do not allow children to ride the Aiper pool cleaner under any circumstances. Please supervise children when they are around an operational Aiper pool cleaner.
4. Use only authorized Aiper power adapters.
5. The adapter cord should only be replaced by a qualified electrician or Aiper Customer Care.
6. It’s suggested to plug the power adapter into a power strip or surge protector and not directly into an electrical outlet.
7. Ensure your device is powered off and the charging port is dry before charging. While charging, your Aiper pool cleaner should be kept in a cool place. Do not cover your Aiper pool cleaner while charging as this may cause  components to overheat.
8. Please store the machine indoors or in a cool place when not in use.
9. Do not run your Aiper pool cleaner out of the water as it may lead to over heating.
10. Only certified professionals should disassemble the sealed driving kit of your Aiper pool cleaner.
11. Do not operate your Aiper pool cleaner and pool filter simultaneously.
12. The oit sealing around the motor contains grease, which may cause a small amount of water pollution if the motor is damaged. If you believe there is a leak, stop using the unit immediately.
13. Do not pierce the shell of your Aiper pool cleaner, throw, or damage the cleaner intentionally.
14. When putting your device into the water, the front of the machine must face upwards and should never be placed upside down or directly thrown into the swimming pool.

FCC Statement
Note: This equipment has been tested and found to comply with the limits according to Part 15 of the FCC Rules of a Class B digital device These imits are designed to provide reasonable protection against harmful interference ina residential installation This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may Cause harmful interference to radio communications or persons However, there is no guarantee that interfer­ ence will not occur in a particular installation tf this equipment does Cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one  or more of the follow­ ng measures

• Reorientate or relocate the receiving antenna increase the separation between the equipment and receiver
• Plug the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the manufacturer or an experienced radio/TV technician for help
• Please note that changes or modifications of this product are not expressly approved by the party responsible for compliance (Aipen), and unauthorized modifications could void the user’s authority to operate the equipment

Compliance Declaration
This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions (l) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference  that may cause undesired operation Importer Aiper intelligent, LLC
Address. 2700 Cumberland Parkway, Suite 350, Atlanta, Georgia 30339
Telephone +1-866-850-0666

Please read this user manual carefully before operating the device.

Structure

Specifications & Working Conditions

1. Pool Size: 1614 sq.Ft/150m?
2. Charger Input: 100-240V, 60/50Hz, 5A
3. Charger Output: 29.4V/3A
4. Charging Time: 3-4h
5. Battery Life: Up to 140 Minutes
6. IP Grade: IPX8 Waterproof
7. Max Water Depth: 10ft (3m)
8. Motor Power: 70W
9. Battery Pack: 7800mAh
10. Battery Pack Voltage: 25.2V

CAUTION:
Your Aiper pool cleaner is best used in the water conditions detailed below

• Temperature 50-95F (10-35C)
• pH Value. 70-7.4
• Chlorine Maximum 4 ppm
• NaCl Maximum 5000 ppm

Using Your Aiper Pool Cleaner

a. The machine is suitable for cleaning floors, walls, and water lines up to 1614sq Ft50mt

Installation

a. Lift the tail end of the upper shell to open and gain access to the interior of the device

b. insert the flter basket into the open slot as indicated in the graphic

c. After installing the filter basket, press down on the tail of the upper shell to close the device

Operating Your Device

a. Turn the dial clockwise to activate each cleaning moe There are three cleaning modes to choose from

The machine will clean the pool floor and wall in turn After cleaning the pool floor, wall cleaning will be conducted when the battery reaches below 10 the machine will stop cleaning and remain parked near the wall of your pool.

The machine will clean the pool floor along the S-shaped route (WavePath™ Navigation Technology ) without climbing the wall

The machine will clean the wall along the N-shaped route No floor cleaning will be carried out under this mode
b. Place your device into your pool Your device will begin cleaning within 10 seconds of reaching your pool’s floor

c. After completing its cleaning cycle, or when the battery is low, your device may be retrieved from the pool using the provided hook. The unique design of the spring plate allows for rapid drainage of the device when taken out of the pool

Disassembly and Cleaning

a. Lift the tear end of the top shell to check the filter basket

b. Detach the fasteners to release the basket from the device

c. Open the tab of the filter basket

d. Remove any trash, wash the filter basket with water, and reinsert the filter basket into the device

Charging

a. Charging
Fully charge your Aiper pool cleaner before using it to clean your pool

• Switch off the power before charging, otherwise the device cannot be recharged, and a rapid alarm will be activated
• Please remove the silicone plug before charging
• Wipe dry the charging port before charging your device

b. Please plug the silicone plug back in after charging or before cleaning your pool

Maintenance & Storage

8.1 Replacement instructions for wheel
a. Lift up the wheel cover marked with an A.

b. Remove the screws foxed to the wheel

c. Remove the shaft and sleeve cover of the wheel for complete disassembly

8.2 Replacement instructions for Rolling Brush Belt
a. Locate the back side of the rolling brush belt and peel back the silicone buckle attached to the mounting slot

b. Once all the silicone buckles are removed, replace the rolling brush belt with a new one. Align the silicone buckles with the mounting slots, and press to secure the buckles into each slot

LED Indicator

Machine
Condition| Indicator
Condition| Sound| Description
---|---|---|---
Battery
State| The
corm- sponding mode indicator and ring indicator are always on.| A “ding” sound will occur
every time the button is turned.| The indicators color will relate to the
device’s battery status.| Green: >90,L
Blue:50-89%,
Yellow:10-49%
Red: < 9%
Charging| Operating Properly| The
Switch icon indicator
is always
n; the
ri
ong indicator flashes
slowly| No sound.| When charging, the ring indicator will flash differ-ent colors corresponding to the appropriate bat-tery states.
After being fully charged, the machine will auto-matically stop charging, and the ring indicator will turn green.
Operating
Improperly| The mode indicator is off| Constant and rapid alarm| If the switch icon indicator is disabled or a cleaning mode is enabled, the mode indicator will turn on, the ring indicator is off and the machine is not charging.
To charge the device, turn the button to the switch icon.

Packing List

Warranty

This product has passed quality control and safety test conducted by our technicians

1. This product comes with a 24 month warranty that covers your item’s battery and motor from the date of purchase
2. This warranty is voided if the product has been altered, misused, or has been repaired by unauthorized persons
3. This warranty extends only to manufacturing defects and does not cover damage resulting from the mishandling of the product by the owner
4. The order number or record of purchase must be presented at the request of any repair claim during the warranty period

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>