polyga VISION V1 3D SENSOR User Guide
- June 4, 2024
- polyga
Table of Contents
polyga VISION V1 3D SENSOR
GETTING STARTED
This quick start guide provides you with the resources to get you started on 3D scanning.
- Factory Calibrated Scanner for capturing 3D data
- FlexScan3D 3.5, SBSDK 3.0 for 3D scanning, mesh processing and measurement tools.
Downloading FlexScan3D Software
You can download the software from the
Polyga Accounts Page or by contacting your distributor.
To create a download account, please contact us at Email:
support@polyga.com
Web: www.polyga.com/contact/
Instructions for installing and activating FlexScan3D using an installation ID or dongle can be found in the User Manual
SETTING UP THE VISION V1
- Connect the 3d sensor to the computer via a USB 3.0 A to B cable. Plug in and fasten the 12V DC power connector. Make sure the port used on the computer side supports USB 3.0 data transmission speed. It is suggested to use a powered USB hub for this connection.
- Turn on the sensor using the back plate button.
The blue LED should light up once the button is pressed.
Open FlexScan3D 3.5 and go to the Scanners Panel tab.
Select the New button to connect to a new scanner.
The software will find all connected scanners, select the corresponding serial
number.
Click OK to finish adding the device.
Change to the Project tab on FS3D. Create or open a project to manage your captured meshes.
CONFIGURE SCANNER
Select Handheld Mode to set the scanner to continuous capture.
Place the object being scanned within 400 to 600 mm from the front plate of the sensor. Change the projector pattern to PHASE/FOCUS for live view with the scanning parameters.
Set the gain slider to its lowest value. If the live view still seems to be dark, slowly adjust the gain value until the live view has proper brightness
Toggle the projector brightness making sure the object of interest is not under-exposed (blue) nor over-exposed (red).
The object of interest should have a light-grey/white appearance on the live view.
CAPTURE DATA
Live Point Cloud Visualization
Check the Capture Only option on the left pane.
Click on SCAN to see the live view captured point cloud.
Object Reconstruction
Make sure the Capture Only option is unchecked.
Once you are done capturing, click on the STOP button and select YES to save the resulting point-cloud.
To convert the point-cloud to a mesh, use the Finalize button on the mesh editor to generate the faces and finalize the raw data.
Select the mesh generation parameters and click OK.
POLYGA SB SDK
After finish getting started with the V1, take the next step using Polyga’s SBSDK 3.0 to integrate your new 3D Sensor with your application.
For SBSDK information visit : www.polyga.com/sbsdk/
CUSTOMER SUPPORT
For access to support resources & troubleshooting guides, visit www.polyga.com/hdi-support-center/
If you have any questions, please contact:
Email: support@polyga.com
Phone: +1 604-293-1767
Web: www.polyga.com/contact/
References
- Polyga - 3D Scanning Hardware and Software - Home
- Polyga Contact
- SB SDK - Programmable API's for Building 3D Scanning Apps
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>