Amazon Basics B07V7QJG8J 1500W Oscillating Ceramic Heater User Manual
- June 15, 2024
- amazon basics
Table of Contents
Amazon Basics B07V7QJG8J 1500W Oscillating Ceramic Heater
IMPORTANT SAFEGUARDS
Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.
-
When using electrical appliances, basc safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:
-
Read all instructions before using this product.
-
Keep this instruction manual for future use. Should this product be passed on to a third party, then this instruction manual must be included.
-
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
-
Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
-
Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
-
Do not use outdoors.
-
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or Other water container.
-
Do not run cord under the carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from trafficked areas and where it will not be tripped over.
-
To disconnect the heater, turn the controls to off, then remove the plug from the outlet.
-
Do not insane or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater,
-
To prevent a possible fire, do not block air intakes or exhaust in any manner, Do not use on soft surfaces, like a bed, where openings may become blocked.
-
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored. use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
-
Always plug heaters directly into a wall outlet/receptacle.
-
Never use an extension cord or relocatable power tap (outlet/power strip).
-
Before connecting the appliance to the power supply, check that the power supply voltage and current rating correspond with the power supply details shown on the appliance rating label.
-
To avoid damaging the cord, do not squeeze, bend or chafe it on sharp edges. Keep it away from hot surfaces and open flames as well.
-
Do not operate the appliance with wet hands or while standing on a wet floor. Do not touch the power plug with wet hands.
-
Do not open the appliance casing under any circumstances,
-
Do not place heavy objects on top of the appliance.
-
Do not place objects with open flames (e.g. candles) on top of or before the appliance
-
Do not place objects filled with water (e.g. vases) on or near the appliance.
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack Of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by persons responsible for their safety.
-
Children should be supervised to ensure that they do not play with the appliance.
-
Risk of burns! Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
-
Do not pull the power plug out of the electrical outlet by the power cord and do not wrap the power cord around the appliance.
-
Connect the power plug to an easily reachable electrical outlet so that in case of an emergency the appliance can be unplugged immediately. Pull the power plug out of the electrical outlet to completely switch off the appliance. use the power plug as the disconnection device.
-
Disconnect the power plug from the electrical outlet when not in use and before cleaning.
-
Always turn the appliance off before disconnecting the power plug.
-
The heater must not be located immediately below a socket outlet.
-
WARNING
This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided. -
To avoid damage to the appliance, always use it in an upright position.
-
When using this appliance for the first time, a slight, temporary odor could develop. This is due to manufacturing residues, which are burning off. Ensure for sufficient room ventilation. Should a fire break out, pull the plug out of the power outlet or otherwise separate the appliance from the power source first before using appropriate fire-fighting measures.
-
To avoid overheating, do not cover the heater.
SAVE THESE INSTRUCTIONS
What’s in the Box
- Front grill
- Power indicator
- Thermostat knob
- Oscillator switch
- Power knob
- Tip-over switch
Intended Use
- The heater is intended for temporarily heating residential rooms.
- The heater is intended solely for indoor non-commercial use.
- Use the product only as described in this manual.
- No liability will be accepted for damage resulting from improper use or non-compliance with this manual.
Before First Use
- Carefully remove all packaging materials and retain them for future use.
- Check for transport damages.
- Place the product on a stable, flat, and heat-resistant surface.
- Set the power knob to the (Off) position before plugging the product into the power source.
- Plug the product into a suitable power source.
Operation
Risk of burns! The heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces.
The power indicator stays on as long as the power plug is connected to the
power source.
Set the power knob to the desired setting:
The heater is off.
Ventilation only. No heating.
Heating mode – Low volume.
Heating mode – High volume (1500 Watts).
Max Temperature.
Min Temperature.
Overheating protection. The product will automatically shut off when it
overheats. Unplug the product from the power source and let it cool for at
least 30 minutes.
Oscillator switch
- Set the oscillator switch to I to activate the oscillation.
- Set the oscillator switch to O to stop the oscillation.
Mode Setting
- To start the heater operation, turn the Thermostat control clockwise to the highest setting.
- Switch the Selector to your desired heat settings:
- Fan Only (Fan)
- Low Heat (LO)
- High Heat (HI)
- The power light will remain lit during operation.
Thermostat Control
- Turn the thermostat control clockwise to the highest position to start the heater. Allow the heater to operate and warm up the room.
- When the desired temperature/comfort level is reached, lower the temperature setting by turning the Thermostat Control counter-clockwise until the heater stops operating.
- The thermostat will automatically maintain the pre-set temperature level by turning the heater ON and OFF.
It is normal for the heater to cycle on and off to maintain the preset temperature. To prevent the heater from doing so, increase the temperature with the thermostat knob.
It is normal for the heater to cycle on and off to maintain the preset temperature. To prevent the heater from doing so, increase the temperature with the thermostat knob.
Tip-Over switch
The heater is designed to automatically shut off when tipped over. When
returned to the proper upright position, the heater will resume normal
operation.
Overheat shutdown
The product will automatically shut off when it overheats. Make sure the
heater is clear of all obstructions. Reset the product to resume normal
operation. (see Troubleshooting).
Cleaning and Maintenance
WARNING
Risk of electric shock! To prevent electric shock, unplug before cleaning.
WARNING
Risk of electric shock! During cleaning do not immerse the electrical parts of
the product in water or other liquids.
Never hold the product under running water.
Cleaning
- To clean, wipe with a soft, slightly moist cloth.
- Dry the product after cleaning.
- Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.
Storage and Maintenance
- When not in use, store the product in its original packaging.
- Do not wrap the cord around the product.
- Store the product in a cool, dry place.
Troubleshooting
Problem
If the heater does not operate:
Solution
- Check if the power plug is connected to the power outlet. Check if the power outlet works.
- Set the power knob to (Off) position and unplug the product from the power source.
- Plug another product to the power source to confirm that it’s working.
- Let the heater cool for 30 minutes.
- Move all obstructions from the surroundings of the heater.
DANGER
- Risk of electric shock! Do not attempt to repair the product yourself. In case of malfunction, repairs are to be conducted by qualified personnel only.
- The product has no user-serviceable parts. Do not disassemble the product.
Specifications
Feedback and Help
Love it? Hate it? Let us know with a customer review.
AmazonBasics is committed to delivering customer-driven products that live up
to your high standards. We encourage you to write a review sharing your
experiences with the product.
amazon.com/review/review-your-purchases
amazon.com/gp/help/customer/contact-us
FAQs
Q: What is the model number of the Amazon Basics heater we are discussing?
A: The model number is B07V7QJG8J.
Q: What type of heater is the Amazon Basics B07V7QJG8J?
A: It is an oscillating ceramic heater.
Q: What is the power rating of the Amazon Basics B07V7QJG8J heater?
A: It has a power rating of 1500W.
Q: Does the Amazon Basics B07V7QJG8J heater come with an oscillating feature?
A: Yes, it features an oscillating function.
Q: What are the dimensions of the Amazon Basics B07V7QJG8J heater?
Q: What safety features does the Amazon Basics B07V7QJG8J heater have?
A: It typically comes with safety features such as overheat protection and tip-over protection.
Q: Can you control the temperature on the Amazon Basics B07V7QJG8J heater?
A: Yes, it often includes temperature control settings.
Q: What type of heating element does the Amazon Basics B07V7QJG8J heater use?
A: It uses a ceramic heating element.
Q: How does the oscillating feature work on the Amazon Basics B07V7QJG8J heater?
A: The oscillating feature causes the heater to rotate from side to side, distributing heat evenly.
Q: Can the Amazon Basics B07V7QJG8J heater be used in a small bedroom?
A: Yes, it is suitable for heating small to medium-sized rooms, including bedrooms.
Q: Is there a remote control included with the Amazon Basics B07V7QJG8J heater?
A: Yes, the Amazon Basics B07V7QJG8J heater typically includes a remote control for convenient operation.
Q: Does the Amazon Basics B07V7QJG8J heater have a timer function?
A: Yes, the Amazon Basics B07V7QJG8J heater often comes with a timer function that allows you to set a specific time duration for the heater to operate before automatically turning off. This can be a helpful feature for energy savings and convenience.
Download This Manual PDF:Amazon Basics B07V7QJG8J 1500W Oscillating Ceramic Heater User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>