DOMETIC CA27328P Dual Connection Throttle and Shift Kit Instruction Manual
- June 15, 2024
- Dometic
Table of Contents
DOMETIC CA27328P Dual Connection Throttle and Shift Kit
Important Information
NOTICE!
Installer: These instructions contain important safety information and must be
forwarded to the boat owner.
CAUTION!
Read these instructions thoroughly before proceeding with installation. Check
contents of kit against parts list on this instruction sheet. Parts supplied
must be used per instructions. Dometic cannot accept responsibility for the
integrity of installations in which substitute parts are used.
Parts supplied in this kit are to be used to connect two 3300/33C type engine control cables (manufactured by Dometic) to a single throttle or shift arm on an inboard or I/O engine.
NOTE
A support bracket similar to that shown in figure 4 must be supplied to
provide a mounting surface for the cable bracket assembly. It must be
constructed so that dimensions shown in figure 1, figure 2, or figure 3, may
be maintained, and allow an unrestricted path for cable installation and
operation.
Mounting dimensions shown are measured with the clutch arm in neutral position and the throttle arm in idle position.
-
Figure 1. Shift cable installation
-
Figure 2. Push to open throttle cable installation.
-
Figure 3. Pull to open throttle cable installation.
Installation
- Attach cable bracket assembly (item 1) to mounting bracket as shown in figure 4, using two each machine crews (item 2), lock washers (item 3) and hex. nuts (item 4). Tighten hardware securely.
- Place cables into slots in cable bracket assembly and lock in place with clips as shown in ****figure 4.
| Item No. | Description | Qty. |
|---|
1
2
3
4
5
6
7
8
9
10| Cable Bracket Assembly
Machine Screw 10–24 x 3/4”
Lockwasher No. 10
Hex. Nut No. 10–24
Pivot Pin
Lock washer 1 /4”
Hex. Nut 1/4”–28
Cable Lug
Flat Washer 1/4” ID
Cotter Pin| 1
2
2
2
1
1
1
2
1
1
-
Install pivot pin (item 5) through hole in shift or throttle arm and attach using lock washer (item 6) and hex. nut (item 7) as shown in figure 5. Tighten hardware securely.
NOTE
If throttle arm has a pivot pin installed, remove and replace with one supplied in this kit.
For shift arm application: Place control head shift lever in neutral position. Place engine shift arm in neutral position.
For throttle arm application: Place control head throttle lever in “idle” position. Place engine throttle arm in “idle” position. -
Thread one cable lug (item 8) onto each cable end. Adjust by threading or unthreading until hole in cable lug will pass over pivot pin. Install in the position shown in figure 5, with flat washer (item 9) between cable lugs as shown.
-
Install cotter pin (item 10) through hole in pivot pin and spread tangs to lock into place.
-
Tighten cable terminal nuts (supplied with cables) securely against cable lugs.
Final adjustment
For final adjustment and check-out procedures, refer to instructions supplied with control head assembly.
NOTE
Before operating boat, recheck all hardware for security and re-torque as
necessary. The boat should be operated with caution until the engine control
system has been thoroughly checked out under normal operating conditions to
ensure that the installation is correct and functioning properly.
Customer Support
A complete list of Dometic companies, which comprise the Dometic Group, can be
found in the public filings of:
DOMETIC GROUP AB Hemvärnsgatan 15 SE-17154 Solna Sweden
YOUR LOCAL DEALE
dometic.com/dealer
YOUR LOCAL SUPPORT
dometic.com/contact
YOUR LOCAL SALES OFFICE
dometic.com/sales-offices
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>