FLASH PROFESSIONAL P7200151 Vintage LED Washer User Manual

: June 4, 2024
: FLASH PROFESSIONAL

Table of Contents

INTRODUCTION
SAFETY INFORMATION
PRODUCT INFORMATION
INSTALLATION
CONNECTIONS
OPERATION MANUAL
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FLASH PROFESSIONAL P7200151 Vintage LED Washer User Manual

INTRODUCTION

Thank you for purchasing Vintage LED WASHER 12x30W COB 12 SEKCJI – SHORT Mk2. For safety reasons and to ensure the trouble-free operation, carefully read the instructions.

SAFETY INFORMATION

Installation should be done by qualified personnel in order to minimize the risk of accidental electric shock
Disconnect the power supply before installation.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you notice any signs of damage you should contact your dealer immediately. Do not connect the device to the mains.
Do not use the device in high humidity conditions and at temperatures above 40° C
The device must be installed on stable structures
Always use steel security cable to attach the device to a stable structure
Do not connect power supply to more than 4 devices in series.

PRODUCT INFORMATION

Features

12 sections controlled separately by DMX
16-bit dimming resolution
Various dimming curves for smooth dimming in 8-bit mode
Dim delay (light bulb simulation)
Full DMX signal regeneration
Electronic protection against overheating
THEATRE or DISCO cooling volume modes.
Permanent color correction
Native support for optional wireless DMX module

Specification

Power consumption: 400W
Power supply voltage: 100 – 245V
Voltage frequency: 50/60Hz
Fuse: F7AL
Diode type: COB
Number of diodes: 12
Diode power: 30W
Display: Color LCD
Color: RGBW
Beam angle: 50°
Dimming: Linear: 0 – 100%
Flash frequency (min): 1Hz
Flash frequency (max): 20Hz
DMX standard: DMX 512
Control interface: 4 buttons
Operating modes: DMX512, Auto, Sound-controlled, Master / Slave
Features: 16-bit dimming, various dimming curves, bulb simulation, DMX Signal regeneration, Electronic protection against overheating
AC IN: powerCON
AC OUT: powerCON
DMX IN: XLR – 3 pin
DMX OUT: XLR – 3 pin
IP Rating: IP20
Housing made: Aluminum
Cooling: Active
Height [cm]: 8 [with packaging 16]
Width [cm]: 97 [with packaging 107]
Depth [cm]: 19 [with packaging 22]
Weight [kg]: 5,2 [with packaging 6,4]

INSTALLATION

After removing the packaging, check if the device was not damaged during transport. Before connecting to the mains, make sure that the device is securely mounted. The manufacturer is not responsible for damage caused by unstable mounting.

CAUTION! Always use steel security cable to attach the device to a stable structure. Ensure proper connection to the mains and proper grounding. Make sure that the electrical parameters are consistent with device requirements. All activities, including connecting the device to the mains must be performed by qualified personnel

CONNECTIONS

The device is equipped with the following interfaces:

DMX (in/out): XLR 3-pin socket
Power (in/out): powerCON socket

Connecting DMX signal

The connection is performed using cable with XLR-female -> XLR-Male plugs
CONNECTIONS
Connecting

Voltage specification

Input Voltage	Total Power	Frequency
100~245V	400W	50/60Hz

Connecting power supply

The connection is performed using power cable with PowerCon connector (included). The device must be operated by qualified personnel. Make sure that the power grid supply parameters are consistent with device parameters and limitations are not exceeded.

CAUTION! In the case of cable damage do not attempt to repair. Replacement or repair can be made only on the manufacturer or by a person with appropriate permissions.

Maximum number of devices connected in series: 4

OPERATION MANUAL

Control panel

The control panel is equipped with LCD display and 4 control buttons with the following functions:

ESC – go back from the selected options, go to upper menu, cancel changes
DOWN – choose option, edit parameter
UP – choose option, edit parameter
ENTER edit selected option, confirm changes

DMX channel list

1 section

CH| Classic-6| Classic-8| M-Control-10| Pro-6| Pro-7| RGB| RGBW| RGB 16bit| RGBW 16bit| Flash A-DMX
1| Dimmer| Dimmer| Dimmer| RED| RED| RED| RED| RED| RED| RED
2| Strobe| Strobe| Strobe| GREEN| GREEN| GREEN| GREEN| R fine| R fine| GREEN
3| RED| RED| RED| BLUE| BLUE| BLUE| BLUE| GREEN| GREEN| BLUE
4| GREEN| GREEN| GREEN| WHITE| WHITE| | White| G fine| G fine| WHITE
5| BLUE| BLUE| BLUE| Dimmer| Dimmer| | BLUE| BLUE| Dimmer
6| WHITE| WHITE| WHITE| Strobe| Dimmer fine| | B fine| B fine| EMPTY
7| | Macro/Color| Macro/Color| | Strobe| | White| Strobe
8| | Speed for Macro/Pulse| Speed for Macro/Pulse| | White fine| Macro/Color
9| | Macro background color|
10| | Macro background dimmer|
3 sections

1

| RED| 1| RED| 1| RED| 1| RED| 1| RED| 1| RED
2| Strobe| Strobe| Strobe| Strobe| GREEN| GREEN| GREEN| GREEN| R fine| R fine| GREEN
3|

1

| RED| RED|

1

2

| RED| Dimmer| GREEN|

2

2

2

2

3

| RED| GREEN| BLUE|

3

3

Macro/Pulse

Macro/Pulse

| | Dimmer fine| | G fine| WHITE
21| | Macro bckg color| | Strobe| | BLUE| Dimmer
22| | Macro bckg dimmer| | B fine| EMPTY
23| | White| Strobe
24| | White fine| EMPTY
12 sections (p1)

1

| Dimmer| Dimmer|

1

| Dimmer|

1

| RED|

1

| RED| 1| RED| 1| RED| 1| RED
2| Strobe| Strobe| Strobe| Strobe| GREEN| GREEN| GREEN| R fine| R fine
3|

1

| RED| RED|

1

2

2

| RED|

2

| Dimmer|

2

| RED|

2

2

3

| RED| BLUE| 3| RED| GREEN| 2| RED
10| WHITE| GREEN| WHITE| GREEN| GREEN| 4| RED| GREEN| G fine| R fine
11|

3

3

| Dimmer| BLUE|

3

| Dimmer|

4

| RED|

5

| RED| 4| RED|

3

4

5

| RED| GREEN| 5| RED| BLUE| 3| RED
18| WHITE| WHITE| WHITE| WHITE| GREEN| BLUE| GREEN| B fine| R fine
19| 5| RED| 4| Dimmer| 5| RED| 4| Dimmer| BLUE|

7

| RED| BLUE| 4| RED| GREEN
20| GREEN| Strobe| GREEN| Strobe| WHITE| GREEN| White| R fine| G fine
21| BLUE| RED| BLUE| RED| 6| RED| BLUE| 6| RED| GREEN| BLUE
22| WHITE| GREEN| WHITE| GREEN| GREEN| 8| RED| GREEN| G fine| B fine
23| 6| RED| BLUE| 6| RED| BLUE| BLUE| GREEN| BLUE| BLUE| White
24| GREEN| WHITE| GREEN| WHITE| WHITE| BLUE| White| B fine| White fine
12 sections (p2)

6

| BLUE|

5

| Dimmer|

6

| BLUE|

5

| Dimmer| 7| RED| 9| RED| 7| RED| 5| RED| 4| RED
26| WHITE| Strobe| WHITE| Strobe| GREEN| GREEN| GREEN| R fine| R fine
27| 7| RED| RED| 7| RED| RED| BLUE| BLUE| BLUE| GREEN| GREEN
28| GREEN| GREEN| GREEN| GREEN| WHITE|

10

6

12

9

| RED| BLUE|

9

7

| Dimmer| BLUE|

7

| Dimmer|

10

| RED| | 10| RED| 7| RED| BLUE
38| WHITE| Strobe| WHITE| Strobe| GREEN| | GREEN| R fine| B fine
39| 10| RED| RED| 10| RED| RED| BLUE| | BLUE| GREEN| White
40| GREEN| GREEN| GREEN| GREEN| WHITE| | White| G fine| White fine
41| BLUE| BLUE| BLUE| BLUE| 11| RED| | 11| RED| BLUE| 6| RED
42| WHITE| WHITE| WHITE| WHITE| GREEN| | GREEN| B fine| R fine
43| 11| RED| 8| Dimmer| 11| RED| 8| Dimmer| BLUE| | BLUE| 8| RED| GREEN
44| GREEN| Strobe| GREEN| Strobe| WHITE| | White| R fine| G fine
45| BLUE| RED| BLUE| RED| 12| RED| | 12| RED| GREEN| BLUE
46| WHITE| GREEN| WHITE| GREEN| GREEN| | GREEN| G fine| B fine
47| 12| RED| BLUE| 12| RED| BLUE| BLUE| | BLUE| BLUE| White
48| GREEN| WHITE| GREEN| WHITE| WHITE| | White| B fine| White fine
12 sections (p3)

Macro/Pulse

11

| Dimmer| | 11| RED| BLUE
62| | Strobe| | Strobe| | R fine| B fine
63| | RED| | RED| | GREEN| White
64| | GREEN| | GREEN| | G fine| White fine
65| | BLUE| | BLUE| | BLUE| 9| RED
66| | WHITE| | WHITE| | B fine| R fine
67| | 12| Dimmer| | 12| Dimmer| | 12| RED| GREEN
68| | Strobe| | Strobe| | R fine| G fine
69| | RED| | RED| | GREEN| BLUE
70| | GREEN| | GREEN| | G fine| B fine
71| | BLUE| | BLUE| | BLUE| White
72| | WHITE| | WHITE| | B fine| White fine
12 sections (p4)

CH| Classic-50| 12xClassic-6| M-Control-54| M-Control-76| Pro-51| 12xRGB| 12xRGBW| 12xRGB 16bit| 12xRGBW16bit
73| | Macro/Color| | 10| RED
74| | Speed for Macro/Pulse| | R fine
75| | Macro bckg color| | GREEN
76| | Macro bckg dimmer| | G fine
77| | BLUE
78| | B fine
79| | White
80| | White fine
81| | 11| RED
82| | R fine
83| | GREEN
84| | G fine
85| | BLUE
86| | B fine
87| | White
88| | White fine
89| | 12| RED
90| | R fine
91| | GREEN
92| | G fine
93| | BLUE
94| | B fine
95| | White
96| | White fine
DMX Value| MACRO/COLOR| SPEED channel function
---|---|---
0-5| no function| no function
6-10| Color: red| 0=no function; 1-255 pulse speed
11-15| Color: green
16-20| Color: blue
21-25| Color: cyan
26-30| Color: magenta
31-35| Color: yellow
36-40| Color: light-red
41-45| Color: light-green
46-50| Color: light-blue
51-55| Color: orange
56-60| Color: mint
61-65| Color: sky blue
66-70| Color: light-cyan
71-75| Color: light-magenta
76-80| Color: light-yellow
81-85| Color: white
86-90| Color: white 9000K
91-95| Color: white 6500K
96-100| Color: white 5600K
101-105| Color: white 5000K
106-110| Color: white 4500K
111-115| Color: white 3200K
116-120| Color: white 2500K
121-125| Color: white 2200K
126-130| Macro 1: change R-G-B| Macro speed; slow to fast
131-135| Macro 2: change R-G-B-C-M-Y-W
136-140| Macro 3: change R-G-B-C-M-Y
141-145| Macro 4: change R-M-B-C-G-Y
146-150| Macro 5: fade R-G-B
151-155| Macro 6: fade R-G-B-C-M-Y-W
156-160| Macro 7: fade R-G-B-C-M-Y
161-165| Macro 8: fade R-M-B-C-G-Y
166-170| Macro 9: fade R-OR-Y
171-175| Macro 10: fade R-V-B-M
176-180| Macro 11: fade G-C-B-V
181-185| Multi-section macro 1: chaser forward
186-190| Multi-section macro 2: chaser backward
191-195| Multi-section macro 3: chaser smooth forward
196-200| Multi-section macro 4: chaser smooth backward
201-205| Multi-section macro 5: 21/12
206-210| Multi-section macro 6: 21/12 smooth
211-215| Multi-section macro 7: in-out forward
216-220| Multi-section macro 8: in-out backward
221-225| Multi-section macro 9: in-out smooth forward
226-230| Multi-section macro 10: in-out smooth bacward
231-235| Multi-section macro 11: rainbow
236-240| Sound mode 1
241-245
246-250| Sound mode 3
251-255| Sound mode 4
DMX Value| STROBE
---|---
0-10| no function
11-255| Strobe, slow to fast