Shihui GSH-002 Smart Neon Strip Instructions
- June 15, 2024
- Shihui
Table of Contents
Shihui GSH-002 Smart Neon Strip
PACKAGE CONTENTS
Scan two-dimensional code download APP
Support APP remote control, support IOS system and Android version; Apple devices Require lO$10.0 or higher, while Android devices require Android 4.4 or higher; Scan the QR code on your phone to download the app and install it.
- The light strip is connected to the controller, and the controller USB is plug-and-play
- Scan the QR code below and download the DIMM ing app
- Open Bluetooth, start the app, search for and connect to the controller
- Enjoy the Bluetooth wireless control experience
- Silicone neon, milky white appearance, flexible LED, waterproof/dustproof
Attention
The light strip is waterproof, and the controller/ wire interface is not
waterproof. You need to take waterproof measures yourself
INSTALLATION STEPS
The light strip can only be connected to 5Vvoltage Please make sure that the back surface of your TV is clean from dirt, oils or fingerprints before attempting to apply your LEDStrip. Use an alcohol-based cleaning cloth to wine the hack offer Ty Wipe the surface to make sure it’s clean and dry.
Install accessories
Paste double-sided tape Stick the light strip on the back and wipe it clean Connect the LED light strip to the USB cable Then insert the cable USB port. Open the mobile phone scanning function, scan the QR code, and download the app
INSTALLATION DETAILS
- Find the USB port on the back of the TV. If your TV does not have a USB port, you can use it Any other USB power supply.
- Before stripping, ensure that you are satisfied with the coverage area of LEDStrip Ensure that the USB cable is placed near the USB port and there is sufficient space on the tape Relax to arrive safely.
- The remote receiver must be visible to function properly.
- Expose the adhesive, stick it to the back of the clip, and install the LED strip
- Install on a cleaned surface on the back of the TV. Press and hold for a few seconds to secure.
- Connect the LED light strip to the uSB cable, and then plug the cable into the uSB port.
- After connecting, you can use the remote control or connect to your phone through Bluetooth.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>