ZUNMOS C-2077 Armless Mesh Task Low Back Ergonomic Chair Instruction Manual
- June 15, 2024
- ZUNMOS
Table of Contents
**ZUNMOS C-2077 Armless Mesh Task Low Back Ergonomic Chair Instruction Manual
**
Package List
-
(1)*1 Seat
-
(2)*1 Back
-
(3)*1 Gas Lift
-
(4)*1 Base
-
(5)*5 Casters
-
(6)*2 Bolts
-
(7)*1 Wrench
Assembly Instruction
-
Press the Casters (5)*5 into the holes at the end of each Leg of Base (4).
-
Insert the Gas Lift (3) into the center of the Base.
-
Align Back with Seat, install Back (2) to the Seat (1) with Bolts (6)*2.
-
Align the center hole of the Seat (1) with Gas Lift (3) and press the Seat down until it is fully secured.
Seat Height: Paddle-shaped lever on the right side
To raise:
While taking your weight off chair, lift lever up.
To lower:
While seated, lift lever up.
CAUTION:
- Before using the chair, check to ensure that all bolts are fully tightened.
- Lubricate all parts and tighten all bolts every 6 months or whenever neede
After successful installation please put the chair in a shady outside for 1-2 days.
For longer use
Re-tighten bolts every 6 months by using the enclosed allen-key.
*Using an electric drill can damage the chair. Please re-tighten bolts manually.
Safety Information
Sit in the center of the chair, with your back to the backres
Do not sit at the front edge of the chair
Do not stand on the chair
Do not use the chair with more than one person
Do not push the chair around when a person is sitting in it
Do not push down on the backrest when a person is reclined
Do not place all your weight on only the backrest
[email protected]
(909)637-7665 | (909)637-7593
EST 9:00AM–17:00PM