SKYTECH K-02 Light Stunt Car Instruction Manual

SKYTECH K-02 Light Stunt Car

Product Information

Specifications

• Compliance: Part 15 of the FCC Rules
• Interference: This device may not cause harmful interference
• Receiver Compatibility: Can be connected to any receiver

Frequently Asked Questions

Q: What should I do if the device is not functioning properly?

• A: If you experience any issues with the device’s functionality, please try the following steps:
  • Check that the device is properly connected to the power source.
  • Ensure that all cables and connections are secure.
  • Refer to the troubleshooting section of the user manual for specific guidance.
  • If the problem persists, contact our customer support for further assistance.

Q: Can I modify the device to improve its performance?

• A: No, any changes or modifications not expressly approved by the manufacturer could void your authority to operate the equipment. It is recommended to consult an experienced technician for any modifications.

Product Usage Instructions

Installation

1. Reorient or relocate the receiving antenna to ensure optimal signal reception.
2. Increase the separation between the equipment and receiver to minimize interference.
3. Connect the equipment into an outlet on a circuit different from the one to which the receiver is connected.

Operation

To operate the product:

1. Ensure that the device is properly connected to the power source.
2. Follow the instructions provided by your receiver to establish a connection with the device.
3. If you experience any issues or undesired operation, consult the dealer or an experienced radio/TV technician for assistance.

Maintenance

To maintain the product:

1. Regularly clean the device using a soft, dry cloth to remove dust and debris.
2. Avoid exposing the device to excessive heat or moisture.
3. Do not attempt to open or modify the device as it may void the warranty.

Safety Precautions

When using the product, please adhere to the following safety precautions:

• Do not expose the device to water or other liquids.
• Avoid placing the device near heat sources such as radiators, stoves, or other appliances.
• Keep the device away from direct sunlight.
• Do not block the ventilation openings of the device.
• Unplug the device during thunderstorms or when it will not be used for an extended period.

Thank you for purchasing one of our toy products. To ensure that you get the most out of your new purchase, please read these instructions carefully before using the toy for the first time.
They contain important information on how to operate the product.

Safety Precautions

Note

• This product is not suitable for children aged 8 or under. When using electrical products, precautions must be taken to prevent the risk of an electric shock.
• Ensure adult supervision at all times
• Do not attempt to modify or re-assemble this product. Unauthorized changes may void your right to use the product.
• There are small parts in this product. The children should play it with the guard of the adults, and never swallow the small parts into their mouth.

Caution

• When the wheels of remote control car is rolling, Do not touch it in order to avoid injury of yourself or damage of the car.
• Please do not play by the road or in dangerous places in case of accidents.
• Children should be accompanied by the adult when playing near the water to avoid danger.
• Children under the age of 14 are not allowed to use this product near water.
• Before using the car, make sure the car battery cover screws are tightened. Failure to tighten may cause water damage to the vehicle.
• If recharging is unnecessary, please take the battery out of the remote control vehicle and remote control.

Care and maintenance

• Remove the batteries when you do not plan to use the toy for an extended period.
• Use a damp cloth to wipe the vehicle clean.
• Do not expose the toy to high temperatures, moisture or direct sunlight.
• Do not immerse the toy in water, as this may damage the electrical components.
• If the wheel is too dirty or rolls inflexibly, this may influence the operation experience.
• Please check it and clear up the foreign matters.

Introduce the Function

Introduce the Function of the Remote Control and the Vehicle

Instructions

• Check that the ON/OFF switch is in the “ON” position. The vehicle will not respond to the remote control when the switch is in the “OFF” position.

Using the vehicle

• Switch on the vehicle using the ON/OFF switch.
• Switch on the vehicle ON/OFF switch,make the frequency of the remote control and remote control vehicle match each other.then you can operate the remote control vehicle.
• Switch off the vehicle and remote control after use.
• The playing time is about 15 mins.
• The control rang is about 30 meters, if out of 30 meters rang , it may lose control.

Caution

In order to avoid losing the remote control vehicle or making it lose control, follow the following steps all the time:

1. Turn on the remote control.2.Turn on the remote control car.
2. Turn it off according to the opposite steps.

Inserting the remote control batteries

Remote control

1. Check the ON/OFF switch is in the “OFF” position.
2. Use a screwdriver to loosen the screw.
3. Remove the battery cover.
4. According the polarity indicated inside in the remote control. Put the 2*AA battery into the battery compartment.
5. Put the battery cover back and tighten the screw.

Remote control car

1. Check the ON/OFF switch is in the “OFF” position.
2. Use a screwdriver to loosen the screw.
3. Remove the battery cover.
4. Install the battery as indicated in the picture on the right:
5. Connect the rechargeable battery in the battery pack as indicated in the picture.
6. The version of the AA battery must be guaranteed insert in the correct place.
7. Put the battery cover back and tighten the screw.

Note: If breakdown occurs in the product, please take out the battery for one minute, and then reinstall it. If the breakdown still exists, please replace the battery. The battery can only be installed by the adults.

Charging the batteries

Sketch Map of the Recharging in A Vehicle Battery

Battery charging

• Connect the USS charger to USB output on the computer or AC/DC adaptor.then insert the car charger plug to the USS wire charger.(Make sure in a correct polarity)-Android USS charging line
• A full charge takes 90 minutes. When charging the LED indicator turns into red. when charging is complete, the LED indicator stays off.
• Regularly inspect the toy, battery charger, charging cable, connectors and other components for signs of damage. In the event of any damage, discontinue use and send the parts for repair.
• In case of abnormal responses such as suspicious peculiar smell, noise or smog in the charger.please remove the power supply at once.
• Please recharge with the dedicated USS delivered by the original factory. Never use broken USS or USB of other brands.
• Please do not recharge the swelling, leaking or broken battery.
• Please do not overcharge the battery. When the battery is fully recharged, please pull out the charger.
• Please do not recharge on the surface of the objects near inflammable things(carpet, wood floor. solid wood furniture, etc.) or of conductive things. While recharging, please keep the battery within the range of visibility.

Battery safety information

1. The batteries must only be charged under adult supervision.
2. Before charging the batteries, remove the battery compartment from the vehicle chassis.
3. Remove empty batteries from the vehicle and remote control.
4. Ensure that the vehicle is switched off before inserting the batteries.
5. Install the battery according to the instruction inside the battery box. Make sure not to confuse the positive and negative polarity of the battery.
6. Do not attempt to charge non-rechargeable batteries.
7. Do not short circuit the battery terminals.
8. If you do not plan to use the vehicle for an extended period, remove the batteries from the vehicle and remote control to prevent leakage.
9. Do not throw batteries into open flames, as this may cause them to explode or leak.
10. Do not mix old and new batteries or batteries from different manufacturers.
11. Only use batteries from recommended or reputable manufacturers.
12. Regularly inspect the batteries for signs of leakage.
13. It is suggested not to use more than 3 batteries for one single play.
14. If leaking occurs in the battery, please avoid touching the liquid with the skin and eyes.If it touches the skin, please clean the skin with soap and clean water at once. If it touches the eyes, please wash the eyes with a lot of cold water at once and see the doctor right away.
15. This equipment is composed of electronic components and battery. The electric appliance garbage should be given special care according to the local requirements for garbage disposal.
16. Keep this instruction manual in a safe place for future reference. It contains important information on how to use the product safely.

Function and Operation

Function and Operation of the Product

FCC STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>