WaterSense FM2893 0123 Stand Alone Water Closet Instruction Manual

June 15, 2024
WaterSense

WaterSense logo STAND ALONE WATER CLOSET
INSTALLATION INSTRUCTIONS
FM2893
0123
Supersedes
0320

FM2893 0123 Stand Alone Water Closet

Installation of Toilet Seat and Cleaning:
It is recommended that toilet seat and cover be installed after all trades are finished.
NOTE: All measurements for roughing-in should be taken from finished wall/floor. It is strongly recommended by the manufacturer that installation is carried out by a licensed plumber.

Cleaning Recommendations

The high quality vitreous china finish on all sanitary ware can be maintained by simply using mild soapy water and wiping over. Sanitary ware should not be cleaned with abrasive materials (e.g. steel wool/ scourers). Do not use any corrosive or abrasive cleaning agents containing acids or scouring agents as this may lead to surface damage.
Bleaches can also discolor seats and hinges and therefore should not be used. If your toilet has metal hinges, they should only be cleaned with a mild liquid domestic cleaner, with soft soapsuds or steel & chrome cleaner.
After cleaning, rinse with clean water and polish with a clean, soft cloth.

  1. Rough in position of water supply inlet, waste outlet and floor fixing bracket holes. WaterSense FM2893 0123 Stand Alone Water Closet
  2. Place rubber seal into bowl recess (do not use sealant). Place tank screws into holes on the inside of the tank, making sure washers are located correctly. Gently lower tank onto bowl, locating mounting screws into matching screw holes in the bowl. Secure tank to bowl by installing nuts and washers from the cavity behind the bowl. Before tightening fully, make sure tank sits square and straight on bowl.WaterSense FM2893 0123 Stand Alone Water Closet - Fig 1
  3. Set up waste pipe so that the end of the bowl collar extends 10- 1/4” (260 mm) from the finished wall.WaterSense FM2893 0123 Stand Alone Water Closet - Fig 2
  4. Align and push fully assembled toilet back to the wall, connecting the bowl spigot to the bowl collar.
    Bucket flush and check for leaks. Connect water supply and test complete unit.WaterSense FM2893 0123 Stand Alone Water Closet - Fig
3

WaterSense logoWhen used with 1.28 gallon tank and fill valve.
© Copyright 2023 All rights reserved.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals