trafag 8439 ECL Submersible Pressure Transmitter Instructions
- June 15, 2024
- trafag
Table of Contents
trafag 8439 ECL Submersible Pressure Transmitter
Warning: Before installation, commissioning, and operation, ensure that
the pressure transmitter is suitable for the application in terms of measuring
range, design and environmental conditions. Non-observance can result in
serious injury and/ or damage to equipment.
Intended use: This instrument converts pressure into an electrical
signal. The instrument has been designed and built solely for the intended use
described here and may only be used accordingly. If the equipment is used
differently, the protection provided by the equipment may be impaired and
Trafag shall not be liable for any claims at all.
Datasheet
Type label description (Example)
Electrical connections
The shield in the device is not connected. In applications with conductive media, the shield and ground on the cable end side must not be connected.
Connection of the measuring equipment
Shield not connected
Installation
The installation of the level probe requires special attention to the venting
tube in the cable which provides the pressure equalisation of the probe with
the environment. The cable end has to be installed in an environment of non-
condensing
humidity.
Connection of the level probe
In general, the cable of the level probe should not be shortened, because
otherwise the protective filter on the vent tube will be removed and water and
moisture can penetrate. It is recommended to install the cable with a loop at
the terminal
box so that a siphon is formed in which any liquid can collect. Furthermore,
it is recommended that one or, in the case of longer cables, several strain
reliefs are used in the cable installation so that the entire weight of the
cable does not rest
on just one clamping point. A suitable strain relief clamp is available from
Trafag.
Installation with a ventilated terminal box for the safe connection of level probes. The terminal box with integrated ventilation membrane enables the operationally safe connection of level probes. The cable of the level probe with an integrated ventilation tube is connected in the terminal box with the standard cable without a ventilation tube leading to the control unit. The special ventilation membrane on the terminal box enables reliable pressure equalisation but prevents the penetration of moisture that could lead to condensation in the level probe. The cable of the level probe is led through the cable gland into the housing. The cable gland must be tightened in such a way that the cable is securely fastened, but the vent tube in the cable is not squeezed too much.
Cleaning
For cleaning purposes, the black protection cap can be removed. The transmitter should be cleaned with a detergent, compatible with the transmitter materials as listed in the datasheet. It is strongly recommended to refrain from any mechanical cleaning of the ceramic membrane as it is very sensitive and can easily be damaged.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>