FEELON KW8046 Magnetic Wireless Trailer Light Kit Instruction Manual
- June 15, 2024
- FEELON
Table of Contents
FEELON KW8046 Magnetic Wireless Trailer Light Kit
Package Content
Function Instruction
- Short press the button: Start/end up to receive stop tum tail signals from the signal transmitter on the 7 to 4-way plug
- Press and Hold for 3s: Ucense Plate light on/off
- Long press and hold for 15s: To reset matching between the signal transmitter and receiver when you get a replaced new light or a new 7 to 4- way plug.
Mounting
Easy to Install, simply attach the magnet to the surface of the steel.
NOTE
- Before using, Please connect the included 7-to-4 plug with the 7-way or 4-way plug on your vehicle, and then short press to tum on the 7-to-4-way signal transmitter button of each light.
- These light kits are suitable for vehicles with 4-wire tail light systems only (tum signals and brake light are on the same wire). It will not work for vehicles with 5 wire tail light system. Please double-check your trailer wiring plug connector before installation.
Testing
Check if the lights work correctly before each use.
Specification
- Input Voltage: DC5V
- Input Current: 2A
- Working Voltage: DC10-30V
- Radio Communication Range: 30Meters
- Battery Capacity: 2600MAH
- Charging Time: 3 hours
- 100% Battery working time: 1O hour
- Waterproof Rate: IP67
- Operating Temperature: -25 C-65 C
Dimension
Battery Life
The data of the endurance of the battery is for your reference, the it depends on the road condition and driving habit.
Important Note
- Fully charge the battery before use.
- Check the battery life before use.
- Check if the lights work correctly before each use.
- Charge the battery every 6 months if not in use.
- Check lights regularly when use for long hours.
- Replaced lights need to be reset and paired.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.