SUNDING 590C Bicycle Speedometer Instructions
- June 15, 2024
- Sunding
Table of Contents
SUNDING 590C Bicycle Speedometer
Product Information
Specifications
- Model: 590C
- Wireless Transmitter Range: Less than 60 cm
- Magnet Distance from Transmitter: 3~5 mm
Product Usage Instructions
Attaching the Wireless Transmitter
Attach the wireless transmitter to the fork blade of your bicycle using the following steps:
- Use the shims provided to adjust the diameter of the transmitter.
- Fix the transmitter to the fork using cable ties.
- Attach the 600mm magnet to the same side of the fork blade and position it as shown in the manual.
- Ensure that the distance between the transmitter and the magnet is no more than 3~5 mm.
- Make sure the distance between the transmitter and the computer is less than 60 cm.
Checking for Proper Function and Alignment
To check if the speedometer is functioning properly and aligned correctly, follow these steps:
- Spin the front wheel of your bicycle.
- Check if the computer receives normal inputs from the transmitter.
If there is no or weak reaction, adjust the position of the magnet and wireless transmitter until you achieve a proper response.
Frequently Asked Questions (FAQ)
- Q: How do I attach the wireless transmitter to my bicycle?
- A: Follow the steps provided in section 1 of the product usage instructions above.
- Q: What is the model number of the speedometer?
- A: The model number is 590C.
- Q: What is the range of the wireless transmitter?
- A: The wireless transmitter has a range of less than 60 cm.
Bicycle speedometer
Attach the wireless transmitter to the fork blade, using the shims to adjust the diameter, and using the cable ties to fix it to the fork. The magnet is attached on the same side and positioned as shown. Make sure that the distance between the transmitter and the magnet is no more than 3~5 mm, and the distance between the transmitter and the computer is less than 60 cm. To check for proper function and alignment, spin the front wheel with the computer and make sure there are normal inputs. Adjust the position of the magnet and wireless transmitter if there is no or weak reaction.
Model: 590C
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a class B digital device, according to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used under the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. if this equipmemt does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements, This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>