Dobot DT-AC-MAP1-001 Mini Vacuum Pump Box Instruction Manual
- June 15, 2024
- Dobot
Table of Contents
DT-AC-MAP1-001
Mini Vacuum Pump Box (for MG400)
Item no: 2899519
Description of symbols
The following symbols are on the product/appliance or are used in this document or the accompanying operating/installation/maintenance instructions:
| The symbol warns of hazards that can lead to personal injury.
---|---
| The symbol warns of dangerous voltage that can lead to personal injury by
electric shock.
| WARNING
Indicates a hazard with a medium level or low level of risk which, if not
avoided, could result in minor or moderate injury.
| DANGER
Indicates a hazard with a high level of risk which, if not avoided, could
result in death or serious injury.
NOTICE
A situation that, if not avoided, can cause personal injury or damage to the
equipment. For items marked with such signs, depending on the specific
situation, there is sometimes a possibility of significant consequences.
NOTE
Provides additional information to emphasize or supplement important points in
the main text.
Safety instructions
Read this document and the accompanying operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
2.1 General
- The product is not a toy. Keep it out of the reach of children and pets.
- Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
- If you have questions which remain unanswered by this information product, contact our technical support service or other technical personnel.
- Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.
2.2 Handling
- Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
2.3 Operating environment
- Do not place the product under any mechanical stress.
- Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
- Protect the product from high humidity and moisture.
- Protect the product from direct sunlight.
- Do not switch the product on after it has been taken from a cold to a warm environment.
The condensation that forms might destroy the product. Allow the product to reach room temperature before you use it.
2.4 Operation
- Consult an expert when in doubt about the operation, safety or connection of the product.
- If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. DO NOT attempt to repair the product yourself. Safe operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stresses.
Installation and connections
Switch off the main unit completely before installing, connecting and disconnecting components to prevent damage to the main unit.
Technical data
Air pressure range …………………….. -70 to 110 kPa
Noise level ……………………………….. 65 dB
Ingress protection ……………………… IP 20
Rated voltage …………………………… 24 V/DC ±10 %
Rate current……………………………… 0.8 A
Peak current …………………………….. 1.2 A
*2899519_V1_0923_jh_ss_en 996581515-2 I1/O1 en
Documents / Resources
|
Dobot DT-AC-MAP1-001 Mini Vacuum Pump
Box
[pdf] Instruction Manual
DT-AC-MAP1-001 Mini Vacuum Pump Box, DT-AC-MAP1-001, Mini Vacuum Pump Box,
Vacuum Pump Box, Pump Box, Box
---|---