BREEZE24 KUE-36HRG32 A6 Middle Static Pressure Duct Type Air Conditioner Installation Guide
- June 4, 2024
- BREEZE24
Table of Contents
BREEZE24 KUE-36HRG32 A6 Middle Static Pressure Duct Type Air Conditioner
Horizontal Installation
With External pump (9K, 12K models)
Cut both ends of the rubber hose into a straight one, use it to connect the
drain Connector A and the external pump and safety it with clamps on both
ends. Then connect the drainpipe to the Connector B.
With External pump (18K model only)
Drain connector A, B & C are covered with caps originally. Take the cap on
drain connector B off, connect the external pump to drain connector B using a
hose & two hose clamps. Then connect the drainpipe to the connector D.
Plug the external
pump to the “PUMP” pin and the water level sensor to the “CN5” to enable the
pump.
With Built-in pump (24K, 36K, 48K models)
Drain connector A, B & C are covered with caps originally. Connect the
drainpipe to the connector D. 
Vertical Installation
No need pump (Disable pump)
The pump must be disabled while the unit is installed vertically or the pump
assembly is removed from its original position. Open the cover of E-Parts Box
assembly, unplug the “PUMP” pin to disable the pump function, and short
connect ”CN5” plug to disable the water level sensor.
Drain pipe connecting
When installed vertically (up flow), the pump must be disabled firstly. Follow
the 2.1 (Fig.4) steps to disable the pump. For the unit with external pump (9K
,12K &18K models), the whole pump assembly can be removed. Then take the cap
on drain connector off and connect the drainpipe to drain connector .
