COLFULINE HM952 4 In 1 Nose Hair Trimmer Instruction Manual
- June 15, 2024
- COLFULINE
Table of Contents
Instruction Manual for
4-in-1 Trimmer Set
HM952 4 In 1 Nose Hair Trimmer
HOW TO USE CHARGING
- Charging 10-12 hour
- Rating Voltage: AC220-240V(50-60Hz)
- Close power switch.Please insert the plug into the power socket.
The indicator with flash on that is charging.
INSTRUCTIONS FOR HEAD REPLACEMENTS
To change attachments, hold the trimmer body with the switch side facing towards you. Turn the attachment and pull off. Position the replacement attachment at the top of the trimmer body, then push down and attach.
USING THE TRIMMER
Remove blade cap. Slide the switch to the“ON” position. Carefully place blade
of trimmer to your nostril to cut nose hairs.
Use the same procedure for trimming ear, sideburn and eyebrow hairs and beard.
(A) NOSE/EAR TRIMMER
- The Nose Trimmer is designed to remove unwanted hair from the nose or ear areas.
- Gently approach the area to be trimmed. Never force the Nose Trimmer into nose or ear cavities as this can result in injury.
- If you experience any pain or discomfort when using this product STOP using it immediately.
- Always clean the trimmer after use and use the cap to protect the Nose Trimmer head.
(B) EYEBROW TRIMMER
You can use this attachment for trimming unwanted eyebrow hair, fine facial
and ear hair, or any stray body hairs.
(C) SIDEBURN TRIMMER
You can use this attachment for smaller areas such as hairlines and sideburns.
Hold the trimmer so the shaver screen gently touches your skin.
Avoid holding the trimmer at an angle. This will distort the screen and may
cause some skin irritation.
(D) BEARD TRIMMER
You can use this attachment for shave the beard slowly.
CLEANING & MAINTENANCE
Clean your personal trimmer regularly. Be sure switch is turned“OFF” before cleaning.
CLEANING WITH BRUSH
Never expose trimmer body to water. To maintain lubrication, use the enclosed
brush to clean the unit.
Thoroughly brush and blow out hair clippings from the power handle.
CL EANING WITH WATER
Your trimmer’s attachments have rust-resistant, stainless steel cutting
blades that permit the cutting attachments to be rinsed under running water if
you choose. Do not wash attachments when attached to trimmer.
Always keep blade area pointed downward when cleaning.
Only after unit has dried completely should the attachment be used.
- Do not use harsh or corrosive cleaners on the unit or its attachments.
- Do not apply pressure or hard objects to attachments.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>