Vetroo AL-MESH-7C Compact ATX PC Case User Manual
- June 15, 2024
- Vetroo
Table of Contents
Vetroo AL-MESH-7C Compact ATX PC Case
Chassis Dimensions
Specification
- Material: 0.4mm(SPCC) Cold Rolled Carbon Steel
- Chassis Dimensions: (H)411 x (W)220 x (L)452mm
- Motherboard Support: ATX / Micro ATX / ITX
- 1/0 Ports: Type-C / 2 x USB3.O / Audio
- Drive Bays: 2 x (2.5″SSD or 3.5″ HDD)
- PCl Slots: 7
- Max CPU Cooler Height: 160mm
- Max GPU Length: 325mm
- Max PSU Length @ Location: 180mm (Max) @ Front Panel Cooling Fan Support: Top: 120mm x 3 or 140mm x2 Bottom: 120mm x 3 or 140mm x2 Rear:120mm
- Liquid Cooling Support: Bottom: 240mm / 280mm / 360mm
Accessory
Hardware Installation
- Unscrew the top screw and remove the top
- Push and pull up to remove the left and right side panels
- Thorough the top gap of the panel by your hand. pull it out with force and take out the front panel
- Insert power supply into the power compartment, align the holes of power supply and power compartment, pass the screwdriver through the hole on the top and tighten the screws
- Align the holes of fan/radiator and case, tighten with the screws. (It is convenient manage cables that install the rear fanfradiator first and then install the motherboard)
- Support 3x 120mm/2x 140mm fan on the bottom (compatible with 240/280/360mm radiator)AIign the holes of the fan/radiator case, tighten with the screws
- Install the 1/0 panel Of the motherboard to the top first. and then install CPU, RAM and CPU Cooler on the motherboard, after that install the motherboard in the case. insert the power connector Of CPU and motherboard
- Support 24012801360mm radiator on the top (compatible with 3x 120mm/2x 140mm fan) Align the holes of fan/radiator and case. tighten with the screws .(NOTE: The pipe of radiator face to the top panel of case)
- Remove the PCl baffle according to the corresponding PCl slot on the motherboard, insert PCIE devices like graphics card and connect the power cable
- Hard Drive Installation: Support 2x 2.5″ SSD(Compatible with 3.5′ HDD). Take down the drive bay, align holes, and tighten with 4pcs screws
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>