ax-s AX290KA Standalone Access Control Keypad User Manual

ACCESS CONTROL
AX290KA USER MANUAL41100294
v1.0.0

System Components

|
---|---
Proximity and Keypad Reader| 1x Hex Key
4 x Plastic wall plug
4 x Countersunk screws
1x Diode and 1 x Capacitor

Installation

| Release hex screw from the bottom of the keypad
---|---
| (Side View)
Push the keypad up to release from mount plate
| Thread system cable through the cable entry hole then make the system connections (as per the wiring diagram), mount the bracket to the surface and slide the keypad to the mountplate, re- fit the hex screw to secure into position.

Note: if using more than one keypad, ensure that the keypads are mounted a minimum 185cm apart

Wiring Example

Advanced Programming Guide

How to set-up Access Pin Number and Tags

How to set the length of the master Pin.

Note: When the length of the master code is changed, all existing Pin and Tag will be deleted.
How to set-up Access Pin Number

How to set-up Tags in batches (Normal EM125KHz cards)

To end programming|

*Each tag will use up a location number (the locations must)

How to set-up Tags in batches (Tags in consecutive numbers)

To end programming|

*Each tag will use up a location number
Deleting Access Pin or Tag

Changing Programming Pin

Note:  To access keypad’s programming mode, the 4 digit programming code is entered in twice
If forgot the password, turn off the power, press and hold button , connect powert again until
Bi-sound is heard, the password will be reset to default one 1234
Clear all Pin and Tag Data Step Number

Default to Factory Settings

Lock 1 Output Operating Time

I.e.lf setting lock-time as 00 mean, Swipe card or input password once open the door, swipe card or input password again close the door.
Enable & Disable backlight

Default: Enabled the backlight
Enable ‘Buzzer’ Function

*Once the “Buzzer” function is disabled, keypad operation becomes mute.
Enable ‘Tamper Alarm’ facility

Tamper alarm activates the keypad’s internal buzzer and ‘door bell’ output if the light sensor is exposed.
Access Pin Number for Lock 2 Output

Deleting Access Pin for Lock 2

Lock Output Operating Time for Lock 2 Output

I.e.lf setting lock-time as 00 mean, Swipe card or input password once open the door, swipe card or input password again close the door.

User Guide

To release Lock 1

Technical Specification

www.ax-s.co.uk

Documents / Resources

| ax-s AX290KA Standalone Access Control Keypad [pdf] User Manual
AX290KA Standalone Access Control Keypad, AX290KA, Standalone Access Control Keypad, Access Control Keypad, Control Keypad, Keypad
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>