Aztech HP 207X Compatible Toner Cartridge Instruction Manual

June 15, 2024
Aztech

Aztech HP 207X Compatible Toner Cartridge

Product Usage Instructions

Tools Required

  • Tweezers (Tool #1)
  • Diagonal cutting pliers (Tool #2)
  • Chip recycling drill (Tool #3)

Installation of the Chip (without chip)

Step 1: Removing the chip from the original HP cartridge

  • Using the tweezers (Tool #1), reset the chip recycling drill’s tip as shown.
  • Install the drill at the location of the toner chip as shown.
  • Use diagonal cutting pliers to cut the plastic that secures the chip.
  • Use the tweezers to extract the chip.

Step 2: Obtaining the chip for compatible third-party cartridges

  • If you are using compatible third-party cartridges, follow these steps to obtain the chip.
  • Proceed with steps A and B from the previous section.

Step 3: Installing the chip into the new cartridge

  • Using diagonal cutting pliers (Tool #2), cut any remaining plastic or glue if necessary.
  • Reset the chip recycling drill’s tip again and remove it from the cartridge.
  • Align the terminal plate (with the chip) with the cartridge and firmly press to install it.

Note: Make sure the tab on the terminal plate is aligned with the arrow on the cartridge.

Note

  • While printing, will appear on your computer screen a pop-up warning message. To disable the message, click the Snooze button and select “2 months” from the a menu descent. The message will be disabled for a selected period.

Tools required

  • Tweezers (tool #1)
  • Diagonal cutting pliers (tool #2)
  • Drill for recycling of chips (tool #3)

Installation guide

Removing the chip from the original HP cartridge

  • Reset the chip recycling bit by rotating its handle in the direction counterclockwise until the tip is in the red box as shown.
  • Install the drill into the point where the toner chip, such as shown.
  • Make sure the drill is installed in position.
  • Rotate the handle drill clockwise.
  • The chip will be ejected from the chip slot.
  • Use tweezers to extract the chip.
  • Use cutting pliers diagonal to cut the residual plastic or glue (if necessary).
  • Reset the again tip for recycling chips and remove it from cartridge.

If you are using compatible third-party cartridges, follow the steps following to get the chip

  • Use diagonal cut stacks to cut plastic fixing the chip.
  • Use tweezers to extract the chip.

Install the chip into the new cartridge

  • Align the end plate (with the chip) with the cartridge and press firmly to install.
  • Make sure the tab on the end plate is aligned with the arrow on the cartridge.

Note

  • After installing the cartridges, the printer will display a message notice, as shown in the photos.
  • Here Please note that the warning message does not will interfere with the printing process e you could ignore it.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals