YELLORE NG-SB 480V LED Parking Lot Light Instruction Manual
- June 15, 2024
- YELLORE
Table of Contents
LED PARKING LOT LIGHT
INSTALLATION INSTRUCTIONS
- Warning: Do cut off electrical source to avoid electrical shock before installation.
- Installation height should be higher than 1.2m.
- For pole mounting, please complete wiring at accessible handhole on pole.
Step 1: Start installation
Turn the street light to back side, loose the screws on swivel
Step 2: Connect cables
Connect the L, N, GND cables of the lamp to the corresponding , N, GND cables
of lamp pole.
Step 3: Fix lights to lamp pole
Install the light to lamp pole, fasten the screws on the swivel. Adjust the
light to an angle you need.
ELECTRICAL GONNECTIONS-277-480V AC, 50/ 60HZ
PHASE TO NEUTRAL WIRING
Step1:
Make the following electrical connections:
a. Connect INPUT GROUND conductor to GREEN WIRE position of the terminal block
or GROUND conductor of LED driver.
b. Connect INPUT VOLTAGE conductor to BROWN WIRE position of the terminal
block or LINE conductor of LED driver.
c. Connect INPUT NEUTRAL conductor to BLUE WIRE position of the terminal block
or NEUTRAL conductor of LED driver.
STEP 2:
Make sure all excess input wires are pushed into pole, screws are tightened.
STEP 3:
Close cover by firmly pushing cover towards fixture, making sure I that no
wires are pinched and Sealing gasket are fully engaged.
STEP 4:
IF the fixture without a terminal block, please insulate all electrical
connections with wire nuts suitable for at least 90°C.
Input cable should be at least H05RN-F 3×1.0m m² SJTW 18AWG) or outdoor grade
cable with rubber sheathed(not supplied). The cable must have a minimum cross
sectional area of 1.0m m² SJTW 18AWG).
*If the fixture with built-in 3 in 1
dimming function, Please connect INPUT POSITIVE(+) SIGNAL CONDUCTOR TO
DIM+(BLUE WIRE), INPUT NEGATIVE(-) signal conductor to DIM-(WHITE WIRE) of LED
driver.
- Slip Fitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>