HERNEST HEFTAC-8002 Modern Accent Chair Instruction Manual
- June 15, 2024
- HERNEST
Table of Contents
HERNEST HEFTAC-8002 Modern Accent Chair
Product Information
The product model is HEFTAC-8002 HEFTAC-8003. It comes with adjustable back legs and a cushion. The package includes the following components:
- M6x25MM screw x 1
- M6x48MM screw x 4
- M8x35MM screw x 4
- Back legs with adjustable foot cap x 4
- M6 nut x 1
- M8 nut x 1
Product Usage Instructions
Section A: Assembly
- Start by attaching the back legs to the chair frame using the M6x48MM screws. Use one screw for each leg.
- Attach the adjustable foot cap to each back leg using the M8x35MM screws. Use one screw for each foot cap.
Section B: Cushion Installation
- Place the cushion on the chair frame.
- Press down on the back of the cushion to secure it in place.
Section C: Balance Adjustment
- Before tightening any screws, adjust the balance of the whole chair.
- Do not over-tighten any screws at this stage.
Section D: Final Assembly
- Once the balance is adjusted, tighten all screws to 100% using the appropriate tools.
Specifications
- Back legs: Adjustable with foot caps
INSTRUCTIONS
- HEFTAC-8002
- HEFTAC-8003
Notice:
- Follow the installation instructions. Please confirm all accessories are preset before installation.
- Do not fully tighten the screws during initial assembly. Fully tighten screws only once all pieces which are correctly assembled.
- If you encounter any problems during installation, please contact our customer service.
- Please unbox the item from the side with an open-label and put a carpet on the floor to avoid scratching it.
Recommended installers: 2
Perore capacious the floor
Estimate installation time: 30 minutes
ASSEMBLY INSTRUCTIONS
- Back legs with adjustable foot cap.
- Please press the back down the cushion.
- Adjusting the balance of the whole chair Tight all screws to 100%.
Please do NOT over-tighten all screws before adjusting balance of the whole chair.
FAQ’s
Should I tighten all screws before adjusting the balance of the chair?
No, please do NOT overtighten all screws before adjusting the balance of the whole chair. Follow the instructions provided.
Read User Manual Online (PDF format)
Loading......