hsdoline B01LWI70ST Lithium Ion Drill Driver Screwdriver Set User Guide
- June 14, 2024
- hsdoline
Table of Contents
Amazon Asin B01LWI70ST
B01LWI70ST Lithium Ion Drill Driver Screwdriver Set
Frequently Asked Questions
1. What do I do if my drill will not charge.
A) Check the charger is plugged in correctly. B) Make sure the charger light changes to green before disconnecting, when the light shows green the battery is fully charged. If it shows red the battery is not fully charged so will only operate on low power C) Check the charger connection is fully inserted and secure into the battery connection located at the rear of the battery. D) If the unit will still not charge contact your place of purchase for replacement or contact the customer service department shown in the user manual for replacement charger or battery.
2. My drill does not have enough power to drill a hole.
A) Make sure you are using the correct drill for the correct task ahead. This drill is not a hammer drill so is not powerful enough to drill into brick or concrete. Read the user manual to explain how to use the drill correctly. B) Make sure the torque setting is set to the drill icon for light drilling tasks.
3. I cannot release the chuck to insert or tighten up around by drill bit or screwdriver bits.
A) Simply hold the chuck tightly and operate the drill trigger in forward or reverse to release the chuck.
4. My drill sparks or as a burning smell.
A) The sparking issue is a normal function which is caused as the carbon brushes pass by the commutator. These small sparks are a normal function of the cordless drill operation, please refer to your user manual on page 5 point 9. B) Your drill for the first few uses will sometimes smell of smoke, this is normal and due to all new components in the drill and will disappear normally after the first few uses.
5. My drill is missing components on arrival.
A) Please contact your place of purchase or contact our dedicated customer service helpline by telephone or email both shown in the manual for replacement parts on our next day delivery service.
6. The drill will not operate correctly or keeps slipping in gear.
A) If drilling make sure the torque setting is set to the drilling function for maximum and correct efficiency. B) If user the drill as a screwdriver and the gears keep slipping this is a normal function and could be that you need to change the torque setting on the drill to cope with your task in hand.
If they are anything you are insure of you can contact our dedicated customer service helpline shown in the manual by telephone or email.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>