CEH Technologies CR0487 Bluetooth Transmitter User Manual
- June 14, 2024
- CEH Technologies
Table of Contents
FOLD IN ZIP – ZAG
POWER BUTTON CONTROLS
Singel Tap| Play/Pause music
Answer/End a call
---|---
Double Tap| Enter pairing mode
Pair a second device
Tap and Hold (for 3 seconds)| Turn device on
Turn device off
Tap and Hold (for 8 seconds)| Restart device
LED LIGHT GUIDE
| Power On – Blue LED flashes twice
---|---
| TX Pairing Mode – Blue and red LED flashes alternatively
| Standby Mode (not paried) – White LED flashes twice every 5 seconds
| Standby Mode (paried) – Solid white LED
| Low Battery – Red LED flashes 3 times
| Charging – Red LED on while charging (turns off when fully charged
AUX-IN MODE
-
Toggle Mymamu Link to Receive Mode (RX)
-
Turn on Bluetooth on your phone
-
Select Mymanu Link from the ‘Other Devices’ section
-
Plug Mymanu Link into the audio jack of your desired source
MYMANU LINK
- Power button
- LED Light
- Reset Button
- RX – TX Switch
- 3.5mm audio jack
HOW TO PAIR
Hold the POWER BUTTON for 10 seconds until Mymanu Link flashes blue and red.
Enter earbuds/headphones into Bluetooth pairing mode. Place Mymanu Link near
earbuds/headphones. Mymanu Link will flash white once paired succesfully
Plug Mymanu Link into audio jack of preffered entertainment system.
To pair a second device, tap the POWER BUTTTON twice, and repeat steps 2-4.
For more information
visitwww.mymanu.com/support
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a _ residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
www.mymanu.com
©2017Mymanu Ltd, Mymanu, Mymanu CLIK+ are trademarks of Mymanu Ltd. Other
company or product names mentioned herein are the property of their
respective
owners and may be trademarks or registered trademarks.
FCC ID: 2BCYN-CRO487
Documents / Resources
| CEH
Technologies CR0487 Bluetooth
Transmitter
[pdf] User Manual
CR0487 Bluetooth Transmitter, CR0487, Bluetooth Transmitter, Transmitter
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>