iAlarm SW02-ZB Smart Water Immersion Sensor Linkage Detector Instruction Manual
- June 14, 2024
- iAlarm
Table of Contents
iAlarm SW02-ZB Smart Water Immersion Sensor Linkage Detector
Product Brief
The SW02-ZB water immersion detector transmits information through a wireless transponder according to the impedance change of the detection electrode after being immersed in water.
Specifications
| Model number | SW02-ZB |
|---|---|
| Wireless technology | Zigbee 802.15.4 |
| Wireless transmission distance | 30-50m (indoor) |
| Working frequency band | 2.4GHz |
| Working voltage | DC3V, using 1*CR2450 button battery |
| Low voltage reminder | about 2.4V |
| Working current | <20mA |
| Standby current | <10uA |
| Working environment | Temperature – 10 °C – 50 °C, |
Humidity< 95% RH, no condensation
Physical dimension| ∅ 53*H21 mm
Color| White
APP download and use
Users please scan the following QR code or download and install the “Tuya
Smart” APP in the mobile application market, and register for use after the
installation is complete.
Indicator light description
- Power on-the green light is always on for 3 seconds
- Distribution network-green light flashes quickly
- Working mode-the indicator light is off
- Data reporting-red light flashes once
Battery replacement
No battery is installed in the detector at the factory, please install the
CR2450 battery for use.
The installation steps are shown on the right:
A. Unscrew the battery cover and insert the battery
B. Screw on the battery cover
Preparation before entering the network
- The water immersion detector has been installed with batteries
- The smart gateway has been added to the APP;
- The mobile phone and the gateway access the same WiFi;
- Mobile phones, sub-devices and gateways are within the effective range of the Zig bee network.
Network access settings
a. Open the home page of the APP, select the gateway, and click “Add sub-
device” at the bottom of the page;
b. Long press the network configuration button for more than 5 seconds,
the green indicator light flashes quickly;
c. Click “Indicator is flashing fast” and operate the sub-device to
access the network according to the prompt;
d. After the addition is complete, the device can be found in the “My
Home” list.
Reset the network: Press and hold the network configuration button for 5
seconds and the green indicator will flash quickly, the device will exit the
network and enter the network configuration mode again.
Install
Remove the base and place the transmitter flat in the detection position
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>